Evolution of Microstructure and Precipitation State During Thermomechanical Processing of a Low Carbon Microalloyed Steel
نویسندگان
چکیده
منابع مشابه
Effect of Thermomechanical Processing on the Microstructure and Mechanical Properties of a Duplex Stainless Steel
Duplex stainless steels (DSSS) have a microstructure composed of ferrite and austenite phases that gives them a very good combination of mechanical and corrosion properties. These steels are desirable for many applications in the chemical and petrochemical industries. In the present study, a type of stainless steel was cast, solution annealed at 1200°C for 60 min and then quenched in water. Ini...
متن کاملLow temperature superplasticity and thermal stability of a nanostructured low-carbon microalloyed steel
We describe here for the first time the low temperature superplasticity of nanostructured low carbon steel (microalloyed with V, N, Mn, Al, Si, and Ni). Low carbon nanograined/ultrafine-grained (NG/UFG) bulk steel was processed using a combination of cold-rolling and annealing of martensite. The complex microstructure of NG/UFG ferrite and 50-80 nm cementite exhibited high thermal stability at ...
متن کاملEffect of NbMo Addition on the Precipitation Behaviour of V Microalloyed Steel during Intercritical Annealing
This paper reports on the precipitation behaviour and microstructural evolution in ~20% cold rolled NbMoV and V single microalloyed low carbon steels during intercritical annealing. The microstructure and precipitation behaviour were studied by optical and scanning/transmission electron microscopy and microanalysis, X-ray diffraction technique and Vickers hardness testing. After intercritical a...
متن کاملEffect of solidification rate on microstructure evolution in dual phase microalloyed steel
In steels the dependence of ambient temperature microstructure and mechanical properties on solidification rate is not well reported. In this work we investigate the microstructure and hardness evolution for a low C low Mn NbTi-microalloyed steel solidified in the cooling rate range of 1-50 Cs-1. The maximum strength was obtained at the intermediate solidification rate of 30 Cs-1. This result h...
متن کاملMicrostructure Evolution during Electric Current Induced Thermomechanical Fatigue of Interconnects
We demonstrate the evolution of microstructure and deformation associated with the use of electrical methods for evaluating mechanical reliability of patterned interconnects on rigid substrates. Thermomechanical fatigue in aluminum and copper interconnects was induced by means of low frequency (100 Hz), high density (> 10 MA/cm) alternating currents, which caused cyclic Joule heating and associ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Microscopy and Microanalysis
سال: 2012
ISSN: 1431-9276,1435-8115
DOI: 10.1017/s1431927612013256