Experimental analysis of built-up cold-formed steel lipped channel stub column
نویسندگان
چکیده
منابع مشابه
Comparative Study on Distortional Buckling Strength of Cold-Formed Steel Lipped Channel Sections
Usage of cold formed steel structural components for buildings and structures is gaining popularity in India for a decade. Hot rolled steel member behaviour and design are well developed, whereas the cold formed steel member behaviour and design is not developed fully compared to the rest of the world. The Indian code for cold-formed steel design, IS 801 was revised during 1975, which is in lin...
متن کاملExperimental Investigation on Cold-formed Steel Wall Plate System
A series of tests on cold-formed steel (CFS) wall plate system subjected to uplift force at the mid span of the wall plate is presented. The aim of the study was to study the behaviour and identify the modes of failure of CFS wall plate system. Two parameters were considered in these studies: 1) different dimension of U-bracket at the supports and 2) different sizes of lipped Cchannel. The lipp...
متن کاملOn Cold-Formed Steel Construction
Powder-actuated (also referred to as low velocity or powder-driven) fasteners are commonly used to attach cold-formed steel framing members, usually a track, to a concrete or structural steel support. Although commonly used, their behavior is less well understood than other fasteners such as screws, bolts and welds. The AISI Cold-Formed Steel Design Manual does not explicitly address powder act...
متن کاملFlexural -Torsional Buckling Tests of Cold-Formed Lipped Channel Beams Under Restrained Boundary Conditions
In this paper, tests on flexural buckling ( Lateral – Torsional ) of cold-formed steel(CFS) lipped Channel beams under restrained boundary conditions are described Two point loading for flexural tests have been established for 3.0m span to obtain uniform bending moment. The section sizes selected for testing are 100x50x10 mm, 100x50x15 mm and 100x50x20 mm with 1.6mm and 2.0mm thickness for the ...
متن کاملAnalysis of Sheathed Cold-Formed Steel Wall Studs
The strength of sheathed wall systems is substantially greater than unsheathed walls with the same studs. Testing on studs sheathed on both sides with dry gypsum board demonstrate strength increases as large as 70% over unsheathed studs (Miller and Peköz 1993, Miller and Peköz 1994). The current AISI Specification for sheathed wall stud systems are complicated, only apply when the sheathing is ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: REM - International Engineering Journal
سال: 2019
ISSN: 2448-167X
DOI: 10.1590/0370-44672019720008