Experimental evaluation of cement mortars with recycled brass fibres from the electrical discharge machining process
نویسندگان
چکیده
منابع مشابه
Experimental Study on the Surface Modification by Electrical Discharge Process
The creation of modified layer on metal surfaces using new methods is one of the procedures in surface engineering which can improve the surface mechanical properties. The electrical discharge process is a new method that can form a modified layer on the metal surfaces. This study aims to improve of pure aluminum surface properties through Electrical Discharge process with Monel 400 electrode. ...
متن کاملExperimental Investigation of the Pulse and Plasma Flushing Efficiency in Electrical Discharge Machining
This paper presents a study of the relationship between Electrical Discharge Machining (EDM) parameters on the EDM efficiency factors using a full factorial design, based on pulse on-time, duty cycle and tool polarity parameters in EDM machining of AISI H13 tool steel. The results show that, in positive polarity, the plasma flushing efficiency and pulse efficiency increase according to the puls...
متن کاملAn Optimization on the DIN1.2080 Alloy in the Electrical Discharge Machining Process Using ANN and GA
Electrical Discharge Machining (EDM) process is one of the most widely used methods for machining. This method is used to form parts that conduct electricity. This method of machining has used for hard materials and therefore selects the correct values of parameters which are so effective on the quality machining of parts. Reaching to optimum condition of the DIN1.2080 alloy (D3) machining is v...
متن کاملAn Optimization on the DIN1.2080 Alloy in the Electrical Discharge Machining Process Using ANN and GA
Electrical Discharge Machining (EDM) process is one of the most widely used methods for machining. This method is used to form parts that conduct electricity. This method of machining has used for hard materials and therefore selects the correct values of parameters which are so effective on the quality machining of parts. Reaching to optimum condition of the DIN1.2080 alloy (D3) machining is v...
متن کاملModeling and Simulation of Micro Electrical Discharge Machining Process
ii ACKNOWLEDGEMENTS iv TABLE OF CONTENTS v LIST OF FIGURES ix LIST OF TABLES xiii CHAPTER
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Construction and Building Materials
سال: 2020
ISSN: 0950-0618
DOI: 10.1016/j.conbuildmat.2020.118522