Experimental study on micro electrochemical slab milling using disc tool electrode
نویسندگان
چکیده
منابع مشابه
Tool Run-Out Measurement in Micro Milling
The interest in micro manufacturing processes is increasing because of the need for components characterized by small dimensions and micro features. As a result, researchers are studying the limitations and advantages of these processes. This paper deals with tool run-out measurement in micro milling. Among the effects of the scale reduction from macro to micro, tool run-out plays an important ...
متن کاملFeasibility of Tool Condition Monitoring on Micro-Milling Using Current Signals
This paper reviewed existing studies in the area of tool condition monitoring. The review revealed the substantial amount of works that have been done in the area of tool condition monitoring in machine tool. However, it was observed that investigating the feasibility of using the main spindle and feed motor currents for tool condition monitoring in micromachining has not been carried out despi...
متن کاملModeling micro - end - milling operations . Part II : tool run - out
The effect of run-out is clearly noticed in micro-end-milling operations, while the same run-out creates negligible change at the cutting force profile of conventional end-milling operations. In this paper, the cutting force characteristics of micro-end-milling operations with tool run-out are investigated. An analytical cutting force model is developed for micro-end-milling operations with too...
متن کاملMicro ring–disk electrode probes for scanning electrochemical microscopy
The construction and characterisation of ring–disk (RD) microelectrodes suitable for use in scanning electrochemical microscopy (SECM) is reported. Such RD electrodes are proposed as probes for novel generator–collector SECM experiments. In this case, the interaction of both the reactants and products with the substrate under investigation can be followed simultaneously from a single approach c...
متن کاملModelling and experimental analysis of the effects of tool wear, minimum chip thickness and micro tool geometry on the surface roughness in micro-end-milling
Tool wear, minimum chip thickness and micro tool geometry are found to have a significant influence on the surface roughness through experimental analysis of the micro-end-milling process. To address these issues, a surface roughness model is developed and validated in this present work. Firstly, experimental analysis for the tool wear and surface roughness was performed based on the micro-end-...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia CIRP
سال: 2020
ISSN: 2212-8271
DOI: 10.1016/j.procir.2020.03.154