Experimental study on two-phase flow pressure drop in small diameter bends

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Two Phase Flow Pressure Drop Calculation Using Homogeneous Equilibrium Model

Although two-phase flow is frequently encountered in various location of the process plants, there is no a general accepted and verified two-phase flow model that may be used to size lines for such conditions. An obvious example is condensate water return lines. The API method that used in this study is based on the homogeneous equilibrium flow assumption, that is, equal velocity and equal temp...

متن کامل

Numerical Study of Single Phase/Two-Phase Models for Nanofluid Forced Convection and Pressure Drop in a Turbulence Pipe Flow

In this paper, the problem of turbulent forced convection flow of water- alumina nanofluid in a uniformly heated pipe has been thoroughly investigated. In numerical study, single and two-phase models have been used. In single-phase modeling of nanofluid, thermal and flow properties of nanofluid have been considered to be dependent on temperature and volume fraction. Effects of volume fraction a...

متن کامل

Two Phase Heat Transfer Characteristics in a Vertical Small Diameter Tube at Sub Atmospheric Pressure

Two-phase heat transfer is experimentally examined through vertical small diameter tubes, D =1.45 and 2.8 mm using water under a pressure of 50 to 81 kPa and a natural circulation condition. The pool boiling correlation by Stephan-Abdelsalam and the thermosyphon boiling correlation by Imura, et al. predict the measured experimental data in the 2.8 mm tube with an error of -30%. A large heat tra...

متن کامل

Flow visualization and pressure drop for refrigerant phase change and air-water flow in small hydraulic diameter geometries

A comprehensive study of two-phase flow mechanisms and pressure drop in horizontal small hydraulic diameter tubes was conducted. Co-current flow of air-water mixtures in four round tubes and one rectangular tube with hydraulic diameters ranging from 5.5 mm to 1.3 mm were investigated. Bubble, dispersed, elongated bubble, slug, stratified, wavy, annular-wavy, and annular flow patterns were obser...

متن کامل

Effect of diameter on two-phase pressure drop in narrow tubes

0894-1777/$ see front matter 2010 Elsevier Inc. A doi:10.1016/j.expthermflusci.2010.12.007 ⇑ Corresponding author. Tel.: +91 44 2257 4154. E-mail address: [email protected] (A.R. Balakrishna The effect of tube diameter on two-phase frictional pressure drop was investigated in circular tubes with inner diameters of 0.6, 1.2, 1.7, 2.6 and 3.4 mm using air and water. The gas and liquid superficial...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Perspectives in Science

سال: 2016

ISSN: 2213-0209

DOI: 10.1016/j.pisc.2016.06.038