Extended calculation method for determining the pitting load carrying capacity of bevel and hypoid gears

نویسندگان

چکیده

Abstract The flank load carrying capacity of bevel and hypoid gears is mainly limited by the failure modes pitting, scuffing, tooth fracture phenomenon micropitting. By application a standardized calculation method, e.g. according to international standard ISO 10300:2014, first estimation can be made based on macro geometry or gear set. According method B 10300:2014 complexity real reduced virtual cylindrical geometry. regarding micropitting determined using along path contact. However, determination pitting carried out single representative point contact gear. This paper shows an extended for Due allows more precise than current 10300-2:2014 same input data. Within this all relevant factors are explained in detail. Furthermore, verification with results intense validated loaded analysis, corresponding A 10300-2:2014, presented.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Calculation of the Tooth Root Load Carrying Capacity of Beveloid Gears

Printed with permission of the copyright holder, the American Gear Manufacturers Association, 1001 N. Fairfax Street, Fifth Floor, Alexandria, VA 22314-1587. Statements presented in this paper are those of the author(s) and may not represent the position or opinion of the American Gear Manufacturers Association. In this paper, two developed methods of tooth root load carrying capacity calculati...

متن کامل

Constructive and Technological Development of Hypoid Gears

In this paper we present a new method for analyzing and developing the hypoid gears in order to improve their constructive and technological particularities.. The first part describes the methodologies for optimization the backlash. Then, the variation of the normal vectors and curvature is analyzed in the neighbourhood of the contact point. In the final part is presented a method for modelling...

متن کامل

Calculation of Load Carrying Capacity on a Redundant Manipulator

This paper presents a computational technique for determining the maximum allowable load of wheeled mobile manipulators for a desired trajectory. Full load motion of mobile manipulators while carrying a load is an important consideration in their application and motion planning. The number of factors limits the maximum allowable loads, which can be achieved by a mobile manipulator during a give...

متن کامل

Determining Maximum Load Carrying Capacity of Flexible Link Manipulators

In this paper, an algorithm is proposed to improve the Maximum Load Carrying Capacity (MLCC) of exible robot manipulators. The maximum allowable load which can be achieved by a exible manipulator along a given trajectory is limited by the joints' actuator capacity and the end e ector accuracy constraint. In an open-loop approach, the end e ector deviation from the prede ned path is signi cant a...

متن کامل

Dynamic Load Carrying Capacity of Flexible Manipulators Using Finite Element Method and Pontryagin’s Minimum Principle

In this paper, finding Dynamic Load Carrying Capacity (DLCC) of flexible link manipulators in point to-point motion was formulated as an optimal control problem. The finite element method was employed for modelling and deriving the dynamic equations of the system. The study employed indirect solution of optimal control for system motion planning. Due to offline nature of the method, many diffic...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Forschung Im Ingenieurwesen-engineering Research

سال: 2022

ISSN: ['1434-0860', '0015-7899']

DOI: https://doi.org/10.1007/s10010-022-00596-w