Extrusion Pressure Estimation in Axisymmetric Paste Extrusion
نویسندگان
چکیده
منابع مشابه
Prediction of Extrusion Pressure in Vortex Extrusion Using a Streamline Approach
Vortex extrusion (VE) is a severe plastic deformation technique which is based on the synergies between high strain accumulation and high hydrostatic pressure. Such a high amount of pressure, places a mandate to seek the method for investigation of the load under processing conditions. For this, kinematically admissible velocity field and upper bound terms based on Bezier formulation are develo...
متن کاملOptimization of Axisymmetric Extrusion Die Profiles
In this research, optimization process of axisymmetric extrusion dies is proposed. Plastic zone is analyzed using finite element method in the Eulerian system with flow formulation. The die profiles are defined by Bezier curves with six control points. Two effective functions are considered in this research; standard deviation of the strain rate and the rate of energy consumption during extrusi...
متن کاملMethods of Extrusion on Demand for High Solids Loading Ceramic Paste in Freeform Extrusion Fabrication
Fabrication of highly dense parts with complex geometry by paste-extrusion-based solid freeform fabrication processes requires a precise control of the extrusion flow rate to dispense material on demand, which is often referred as Extrusion-On-Demand (EOD). The extrusion process for aqueous ceramic pastes is complex and difficult to control due to their non-Newtonian behavior, compressibility a...
متن کاملSelection of Signal Processing Techniques for Extracting Quantitative Indicators of Paste Quality from Extrusion Pressure Data
Signal processing techniques have been developed for extracting quantitative indicators of the performance of extruders processing soft-solid pastes from the data recorded by pressure transducers located near the extrusion die. Such techniques have been applied previously to isothermal ram and screw devices using retrospective methods. This article reports on the scope for application of retros...
متن کاملA universal velocity ®eld for the extrusion of non-axisymmetric rods with non-uniform velocity distribution in the extrusion direction
This study formulates a universal velocity ®eld that is kinematically admissible for application in the extrusion of non-axisymmetric rods. Then upper bound theorem dictates that a better upper bound solution heavily depends on the precise conformity of the velocity ®eld postulated. However, a compromise must frequently be made, since the formulation is in general rather complicated. The kinema...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: KONA Powder and Particle Journal
سال: 1999
ISSN: 0288-4534,2187-5537
DOI: 10.14356/kona.1999019