Fabrication of a Miniature Paper-Based Electroosmotic Actuator
نویسندگان
چکیده
منابع مشابه
Fabrication of a Miniature Paper-Based Electroosmotic Actuator
PDMS-based films with 14 wt% carbon black were formed with varying amounts of hexane (Sigma-Aldrich) to determine the effect of the solvent on electrical resistance. Five formulations were prepared with hexane at 0, 100, 150, 200, and 300% by weight, relative to the pre-polymer. Without hexane, the suspension was a thick paste that had to be applied by doctor blading; with hexane, the suspensio...
متن کاملFabrication of a miniature CMOS-based optical biosensor.
This work presents a novel, miniature optical biosensor by immobilizing horseradish peroxidase (HRP) or the HRP/glucose oxidase (GOx) coupled enzyme pair on a CMOS photosensing chip with a detection area of 0.5 mm x 0.5 mm. A highly transparent TEOS/PDMS Ormosil is used to encapsulate and immobilize enzymes on the surface of the photosensor. Interestingly, HRP-catalyzed luminol luminescence can...
متن کاملFabrication and Electroosmotic Flow Analysis of Freely-Suspended, 3D Microchannels
Suspended microchannels suitable for electroosmotic flow were fabricated by coating and dissolving sacrificial polymer fibers created by a new technique which involves using a pressurized syringe loaded with solution to directly deposit filaments of solution on the substrate in a “connect-the-dots” style. Additionally, because both the stylus and syringe were controlled with an ultra-high preci...
متن کاملFabrication and electroosmotic flow measurements in micro- and nanofluidic channels
An easy method for fabricating microand nanofluidic channels, entirely made of a thermally grown silicon dioxide is presented. The nanochannels are up to 1-mm long and have widths and heights down to 200 nm, whereas the microfluidic channels are 20-lm wide and 4.8-lm high. The nanochannels are created at the interface of two silicon wafers. Their fabrication is based on the expansion of growing...
متن کاملDesign and Fabrication of a Miniature Railway Vehicle
We present design, fabrication, and characterization of a small (12 mm × 12 mm × 8 mm) movable railway vehicle for sensor carrying. The miniature railway vehicle (MRV) was mainly composed of a vibrational structure and three legs. A railway was designed and fabricated to power and guide the MRV. It also transmits the sensed data from the MRV to the signal processing unit. The MRV with legs on t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Polymers
سال: 2016
ISSN: 2073-4360
DOI: 10.3390/polym8110400