Fabrication of Al2O3-TiN Micro-composite Derived from TiO2 Precursor
نویسندگان
چکیده
منابع مشابه
Fabrication of Porous Al2O3 and TiO2 Thin film hybrid composite using Atomic Layer Deposition and Properties Study
Atomic layer deposition (ALD) has been used in advanced applications where thin layers of materials with precise thickness down to the nanometer scale are needed. Using anodic oxidation, we prepared the porous alumina. Anodic oxidation was carried out in 5 C 0.3M oxalic acid with anodizing voltages (~ 40 V) and two step anodization method. SEM shows that, these porous anodic oxides are well ali...
متن کاملFabrication and Characterization of Rutile TiO2 Nanocrystals by Water Soluble Precursor
In this research, TiO2 nanoparticles were synthesized by a simple wet chemical method. TiCl4 was used as precursor in hydrogen peroxideand ethanol. The TiO2 nanoparticles were characterized by transmission electron microscopy (TEM), scanning electron microscopy (SEM), X-ray diffraction (XRD), electron dispersive spectroscopy (EDS) and UV-Vis spectrophotome...
متن کاملFormulation of Composite Resistive Pastes for Fabrication of Micro- Heaters
We investigate in this work the formulation of composite resistive pastes based on epoxy resins and graphite for micro-heater manufacturing via thick-film technology. These resistive pastes are designed for screenprinting onto a printed circuit board (PCB) substrate; further coating with expandable polydimethylsiloxane (PDMS), a composite based on an elastomeric matrix and expandable microspher...
متن کاملFabrication and deformation behaviour of multilayer Al2O3/Ti/TiO2 nanotube arrays.
In this study, titanium thin films were deposited on alumina substrates by radio frequency (RF) magnetron sputtering. The mechanical properties of the Ti coatings were evaluated in terms of adhesion strength at various RF powers, temperatures, and substrate bias voltages. The coating conditions of 400W of RF power, 250°C, and a 75V substrate bias voltage produced the strongest coating adhesion,...
متن کاملTransparent and flexible capacitors based on nanolaminate Al2O3/TiO2/Al2O3
Transparent and flexible capacitors based on nanolaminate Al2O3/TiO2/Al2O3 dielectrics have been fabricated on indium tin oxide-coated polyethylene naphthalate substrates by atomic layer deposition. A capacitance density of 7.8 fF/μm(2) at 10 KHz was obtained, corresponding to a dielectric constant of 26.3. Moreover, a low leakage current density of 3.9 × 10(-8) A/cm(2) at 1 V has been realized...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 2006
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.53.323