Fabrication of Aluminum Alloy Strip by Roll Caster Equipped with a Scraper
نویسندگان
چکیده
منابع مشابه
Fabrication of Aluminum Tubes Filled with Aluminum Alloy Foam by Friction Welding
Aluminum foam is usually used as the core of composite materials by combining it with dense materials, such as in Al foam core sandwich panels and Al-foam-filled tubes, owing to its low tensile and bending strengths. In this study, all-Al foam-filled tubes consisting of ADC12 Al-Si-Cu die-cast aluminum alloy foam and a dense A1050 commercially pure Al tube with metal bonding were fabricated by ...
متن کاملFabrication of the Cu-Zn multilayer and Cu-Zn alloy by accumulative roll bonding (ARB) with an emphasis on the wear behavior
Accumulative roll bonding (ARB) was used to fabricate the Cu-Zn multilayer and Cu-Zn solid solution. A lamellar structure with the hardness of about 130 VHN was formed after eight ARB cycles. Following to the suitable heat treatment, a solid solution with a uniform microstructure and hardness of about 57 VHN was produced. The dominant wear mechanism in the ARB processed multilayer was found to ...
متن کاملEnhanced Procedure for Fabrication of an Ultrahydrophobic Aluminum Alloy Surface using Fatty Acid Modifiers
A superhydrophobic aluminum surface was fabricated through an enhanced low-cost approach and the effects of several relevant factors on static contact angle and sliding angle were investigated. First, the operating parameters including the etching time as well as the reaction time and temperature were varied. Next, the so-called chemical factors including three different fatty acids and five di...
متن کاملFabrication of synchronized hammer peening with pulsed laser welding and its effect on 6061 aluminum alloy weld
The non-continuous laser beam in pulsed lasers allows the mechanical peening between two consecutive beams on a still hot weld bead. At a very short time (20, 150 and 300 ms) after laser pulse application, mechanical peening was performed on the welding bead. To achieve these short times, the light sensor detects the nth laser pulse and the mechanical arm starts moving. Upon reaching the tip of...
متن کاملFabrication of synchronized hammer peening with pulsed laser welding and its effect on 6061 aluminum alloy weld
The non-continuous laser beam in pulsed lasers allows the mechanical peening between two consecutive beams on a still hot weld bead. At a very short time (20, 150 and 300 ms) after laser pulse application, mechanical peening was performed on the welding bead. To achieve these short times, the light sensor detects the nth laser pulse and the mechanical arm starts moving. Upon reaching the tip of...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 2011
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.77.1069