Fabrication of binary FeSe superconducting wires by diffusion process
نویسندگان
چکیده
منابع مشابه
Superconducting gap structure of FeSe
The microscopic mechanism governing the zero-resistance flow of current in some iron-based, high-temperature superconducting materials is not well understood up to now. A central issue concerning the investigation of these materials is their superconducting gap symmetry and structure. Here we present a combined study of low-temperature specific heat and scanning tunnelling microscopy measuremen...
متن کاملFabrication of Chemically Doped, High Upper Critical Field Magnesium Diboride Superconducting Wires
Controlled chemical doping of magnesium diboride (MgB2) has been shown to substantially improve its superconducting properties to the levels required for high field magnets, but the doping is difficult to accomplish through the usual route of solid state reaction and diffusion. Further, superconducting cables of MgB2 are difficult to fabricate because of the friable nature of the material. In t...
متن کاملHyper-expanded interlayer separations in superconducting barium intercalates of FeSe.
Intercalation of Ba in β-FeSe by ammonothermal synthesis results in the formation of different superconducting phases with interlayer distance ranging between 8.4 and 13.1 Å. The values of Tc are primarily dependent on Ba content, and are further modulated by the interlayer spacing through facile intercalation and deintercalation of ammonia.
متن کاملFabrication of Saddle-Shaped Surfaces by Flame Forming Process
The flame forming process is widely used to manufacture ship hull plates. The saddle-shaped surfaces have different curvatures in perpendicular angles of planes and the manufacturers face an anti-clastic curvature. In this article, the manufacturing of saddle-shaped surfaces utilizing the flame forming process is investigated. The spiral irradiating scheme is used for forming. In order to study...
متن کاملIN-SITU FABRICATION PROCESS OF AL- TIC COMPOSITE BY SLAG
The new in situ method for AI-TiC composite fabrication has been carried out. In this method, fabrication of AI-TiC composite by simultaneous introduction of titanium oxide and carbon into aluminum melt was investigated.. Under the process conditions, titanium and carbon reaction results in titanium carbide whiskers. The salt containing keriolite (Na3AIF6), titanium oxide (TiO2) and graphite us...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Applied Physics
سال: 2012
ISSN: 0021-8979,1089-7550
DOI: 10.1063/1.4726243