Fabrication of Micro Diamond Tools by Electroless Composite Plating and Micro Grinding
نویسندگان
چکیده
منابع مشابه
Novel Electroless Plating of Ruthenium for Fabrication of Palladium-Ruthenium Composite Membrane on PSS Substrate and Its Characterization
This paper focused on a novel method of electroless plating ruthenium (Ru) on solid or porous substrates like porous stainless steel (PSS) discs or ceramic tubes. A novel complexing plating bath of Ru was developed. It is proven that Ru can be deposited directly on these substrates by the bath at a temperature of 328 K and strong alkaline environment. TGA, SEM, EDX and XRD confirmed the success...
متن کاملAn Investigation on Two Types of Crystalline Micro-diamond Film Coated Tools Lapping with Sapphire Wafer
Two types of micron-diamond films were prepared on YG6 substrate by hot filament chemical vapor deposition(HFCVD) method. Morphology and orientation of crystalline growth were evaluated by SEM and XRD. Diamond film coated tools and sapphire wafer’ surface before and after lapping experiment were contrasted. The results indicated that a significant change in Raman spectrum of two types of micro...
متن کاملFabrication of Polymeric Micro needle Array by Micromachining & Micro molding
Microneedles are expected to have greater demand in biomedical applications like sensing, electroporation & drug delivery in the future and there is need for development of fabrication process which is simple, economical and productive. Present work discusses about fabrication of PDMS (polydimethylsiloxane) micro needle array electrode for bio-potential signal measurement like EEG by micromachi...
متن کاملMicro-layered-photolithography for Micro- Fabrication and Micro-molding
A novel process based on the principle of layered photolithography has been proposed and tested for making three-dimensional micro-structures. An experimental setup was designed and built for doing experiments on this micro-fabrication process. An ultraviolet (UV) excimer laser at the wavelength of 248 nm was used as the light source and a single piece of photo-mask carrying a series of two dim...
متن کاملFormulation of Composite Resistive Pastes for Fabrication of Micro- Heaters
We investigate in this work the formulation of composite resistive pastes based on epoxy resins and graphite for micro-heater manufacturing via thick-film technology. These resistive pastes are designed for screenprinting onto a printed circuit board (PCB) substrate; further coating with expandable polydimethylsiloxane (PDMS), a composite based on an elastomeric matrix and expandable microspher...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21
سال: 2007
ISSN: 2424-3086
DOI: 10.1299/jsmelem.2007.4.7e503