Fabrication of Monolayer Particle Arrays by Continuous Coating Process
نویسندگان
چکیده
منابع مشابه
Fabrication of Saddle-Shaped Surfaces by Flame Forming Process
The flame forming process is widely used to manufacture ship hull plates. The saddle-shaped surfaces have different curvatures in perpendicular angles of planes and the manufacturers face an anti-clastic curvature. In this article, the manufacturing of saddle-shaped surfaces utilizing the flame forming process is investigated. The spiral irradiating scheme is used for forming. In order to study...
متن کاملIN-SITU FABRICATION PROCESS OF AL- TIC COMPOSITE BY SLAG
The new in situ method for AI-TiC composite fabrication has been carried out. In this method, fabrication of AI-TiC composite by simultaneous introduction of titanium oxide and carbon into aluminum melt was investigated.. Under the process conditions, titanium and carbon reaction results in titanium carbide whiskers. The salt containing keriolite (Na3AIF6), titanium oxide (TiO2) and graphite us...
متن کاملA facile fabrication process for polystyrene nanoring arrays.
Polystyrene nanoring arrays with outer diameters ranging from 130 to 230 nm were fabricated using low cost and simple fabrication techniques, including nanosphere lithography, argon plasma treatment, immersion in organic solvents and sonication. These nanorings were developed from polystyrene nanospheres pre-assembled on substrates. Scanning electron microscopy revealed that the argon plasma tr...
متن کاملParticle Reduction at Metal Deposition Process in Wafer Fabrication
Metal Deposition or metallization process is one of the processes in fabricating a wafer. A wafer is a thin slice of semiconductor material, such as a silicon crystal, used in the fabrication of integrated circuits and other micro-devices. Due to the nature on the process, it creates lot of particles, which would impact the next process if it were not removed. Particle deposition on the wafer s...
متن کاملFabrication of Nanodiamond Coating on Steel
The hardness, heat conductivity and low friction coefficient of microcrystalline diamond make it a suitable candidate for tribological applications. However, its roughness and high deposition temperature pose significant obstacles to these applications. We have successfully grown nanocrystalline diamond on steel at 400 °C by hot-filament chemical vapor deposition by employing a CrN interfacial ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Powder Technology, Japan
سال: 2008
ISSN: 0386-6157,1883-7239
DOI: 10.4164/sptj.45.98