Fabrication of particle dispersed aluminum alloy composites by compocasting process and their properties.
نویسندگان
چکیده
منابع مشابه
architecture and engineering of nanoscale sculptured thin films and determination of their properties
چکیده ندارد.
15 صفحه اولOptimization of SiC particle distribution during compocasting of A356-SiCp composites using D-optimal experiment design
This paper presents an experimental design approach to the process parameter optimization for compocasting of A356-SiCp composites. Toward this end, parameters of stirring temperature, stirring time, stirring speed and SiC content were chosen and three levels of these parameters were considered. The D-optimal design of experiment (DODE) was employed for experimental design and analysis of resul...
متن کاملSoldering of Aluminum Matrix Composites Sicp/a356 and Kovar Alloy
Article history: Received 28.3.2013 Received in revised form 26.4.2013 Accepted 29.4.2013 Aluminum matrix composites containing 55% SiC particle reinforcing phase/SiC reinforcement phase particle and Kovar alloy 4J29 were chosen as the base metals. After nickel plating on the surface of SiCp/Al, two kinds of materials were soldered together by using Zn-Cd-Ag-Cu as the filler metal and ZnCl2 as ...
متن کاملReviews on the Influences of Alloying elements on the Microstructure and Mechanical Properties of Aluminum Alloys and Aluminum Alloy Composites
In recent year’s aluminum and aluminum alloys are widely used in automotive industries. These are light weight (density of about 2.7g/cc),having good malleability and formability, high corrosion resistance and high electrical and thermal conductivity. High machinability and workability of aluminum alloys are prone to porosity due to gases dissolved during melting processes. However, in the engi...
متن کاملFabrication of Aluminum Tubes Filled with Aluminum Alloy Foam by Friction Welding
Aluminum foam is usually used as the core of composite materials by combining it with dense materials, such as in Al foam core sandwich panels and Al-foam-filled tubes, owing to its low tensile and bending strengths. In this study, all-Al foam-filled tubes consisting of ADC12 Al-Si-Cu die-cast aluminum alloy foam and a dense A1050 commercially pure Al tube with metal bonding were fabricated by ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1988
ISSN: 0451-5994
DOI: 10.2464/jilm.38.626