Fatigue Crack Control in Structural Details Using Surface Peening
نویسندگان
چکیده
منابع مشابه
Side Effects of Shot Peening on Fatigue Crack Initiation Life
Shot peening beneficial effects on fatigue life of mechanical components are well known. However, there are some reports in the literature that indicate inappropriate shot peening parameters tend to reduce the fatigue life. It is therefore, the purpose of this study to find a logical quantitative justification for these observations. Using finite element method, a dynamic elastic-plastic simula...
متن کاملNumerical Study of Fatigue Crack Growth at a Web Stiffener of Ship Structural Details
It is necessary to manage the fatigue crack growth (FCG) once those cracks are detected during in-service inspections. In this paper, a simulation program (FCG-System) is developed utilizing the commercial software ABAQUS with its object-oriented programming interface to simulate the fatigue crack path and to compute the corresponding fatigue life. In order to apply FCG-System in large-scale ma...
متن کاملFatigue Crack Detection Using Piezoelectric Elements
Crack detection using piezoelectric sensors have widely been reported in many research papers. In most of these studies, the cracks considered are generally artificially induced and the piezoelectric sensors are not subjected to fatigue loading. This paper presents a set of fatigue tests results demonstrating the effectiveness of piezoelectric elements in crack detection. The results presented ...
متن کاملAnalysis of Surface Crack Growth under Rolling Contact Fatigue
Understanding the fatigue crack growth phenomenon in railheads requires a study of driving forces such as the crack tip opening and sliding displacements, under repeated rolling contact. Finite element simulations, allowing elastic-plastic deformation, and mixed-mode crack growth laws were utilized to demonstrate that the fatigue crack growth rates display a minimum after a finite amount of cra...
متن کاملEffect of Residual Stresses on Fatigue Strength of Severely Surface Deformed Steels by Shot Peening
The compressive stress distribution below the specimen surface of severely surface deformed steels by shot peening was investigated by using laboratory X-rays and high-energy X-rays from a synchrotron radiation source, SPring-8 in the Japan Synchrotron Radiation Research Institute. Medium carbon steel plates were heat treated in two different conditions. The Vickers hardness of material-A and B...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Ship Production
سال: 2008
ISSN: 8756-1417,1542-0469
DOI: 10.5957/jsp.2008.24.3.147