Fatigue crack growth and crack closure of P/M aluminum alloys.
نویسندگان
چکیده
منابع مشابه
On Crack Closure and Crack Tip Shielding during Fatigue Crack Growth
Fatigue crack growth can be strongly influenced by crack closure, i. e., the contacting of the opposing faces of a fatigue crack above the minimum load in a loading cycle. This crack closure shields the crack tip from the full stress field, but different views are held regarding the extent of this shielding. The type of closure, whether it be plasticity-induced, or roughness-induced may also pl...
متن کاملAn atomistic investigation into the nature of near threshold fatigue crack growth in aluminum alloys
Despite decades of study, the atomic-scale mechanisms of fatigue crack growth remain elusive. Here we use the coupled atomistic–discrete dislocation method, a multiscale simulation method, to examine the influence of dislocation glide resistance on near-threshold fatigue crack growth in an aluminum alloy. The simulations indicate that the threshold increases with an increase in dislocation glid...
متن کاملFatigue Crack Growth Monitoring of an Aluminum Joint Structure
The detection, location, and sizing of a fatigue crack emanating from a fastener hole in an aluminum plate is investigated. Two linear arrays of surface mounted piezoelectric disk transducers send and receive ultrasonic guided waves that are transmitted, reflected, and scattered by both the joint geometry and the fatigue crack. A tomography algorithm is used to detect and locate the crack. Ampl...
متن کاملAnalyses of Fatigue Crack Growth and Closure Near Threshold Conditions for Large-Crack Behavior
A plasticity-induced crack-closure model was used to study fatigue crack growth and closure in thin 2024-T3 aluminum alloy under constant-R and constant-Kmax threshold testing procedures. Two methods of calculating crack-opening stresses were compared. One method was based on contact-K analyses and the other on contact crack-openingdisplacement (COD) analyses. These methods gave nearly identica...
متن کاملFatigue Crack Growth Rate Model for Metallic Alloys
A model has been created to allow the quantitative estimation of the fatigue crack growth rate in steels as a function of mechanical properties, test–specimen characteristics, stress–intensity range and test–frequency. With this design, the remarkable result is that the method which is based on steels, can be used without modification, and without any prior fatigue test, to estimate the crack g...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 1987
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.53.1993