Fatigue microstructural evolution in pseudo elastic NiTi alloy
نویسندگان
چکیده
منابع مشابه
Pseudo-elastic deformation behavior in a Ti/Mo-based alloy
It is shown that the pseudo-elastic response in a series of Ti–Mo–V–Nb–Al alloys with 8–11 wt.% Mo is highly sensitive to both composition and heat treatment. Recovery of up to 3.0% strain has been observed but it appears that this may not be due to reversible formation of a00 martensite. 2003 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
متن کاملMicrostructural evolution during recrystallization in hot rolled Aluminum Alloy 1050
The evolution of texture as a function of recrystallization has been characterized for hot-rolled AA1050. Samples prepared from a hot rolled sheet were annealed isothermally for sufficient time to allow complete recrystallization. The spatial orientation variation within the deformed microstructure of nucleation, growth and orientations of recrystallized grains is examined. The microstructural ...
متن کاملMean Strain Effects and Microstructural Observations during In-vitro Fatigue Testing of Niti
The non-linear nature of the superelastic phase transformation in NiTi means that conventional fatigue life theory is difficult to apply. The volume fraction of martensite/parent phase and its role in the fatigue mechanism is not understood. This paper considers the fatigue life of superelastic NiTi alloys when tested at 2Hz in Ringers solution. In agreement with other researchers [1] [2] it wa...
متن کاملBiocompatibility of NiTi Alloy Implants in vivo
In this study, the powders of Ni and Ti with 50.5 at.% Ni for 12 h were blended and cold pressed at the different pressures (50, 75 and100 MPa).The porous product obtained after Ni-Ti compacts were synthesized by SHS (self-propagating hightemperature synthesis) in the different preheating temperatures (200, 250 and 300oC) and heating rates (30, 60 and 90oC/min). The effects of the pressure, pre...
متن کاملInvestigation of Ca in the Microstructural Evolution and Porosity Analysis of ZK60 Alloy in As-Cast and Extruded Conditions
This research work has been carried out to study the effect of different Ca contents (0.5, 1.0, 1.5, 2.0 and 3.0) on the microstructure and porosity content of ZK60 alloys. The samples were examined by using optical and scanning electron microscopy (SEM) to evaluate the modification efficiency of the alloy with different Ca concentrations. The cast specimens were modified, homogenized and extru...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Structural Integrity
سال: 2016
ISSN: 2452-3216
DOI: 10.1016/j.prostr.2016.06.185