Fatigue Performance of Thin Laser Butt Welds in HSLA Steel
نویسندگان
چکیده
This work is focused on understanding the significant factors affecting fatigue strength of laser-welded butt joints in thin high-strength low-alloy (HSLA) steel. The effects weld profile, imperfections, hardness, and residual stresses were considered to explain results found S-N curves four welded series. showed acceptable although series presented multiple-imperfections. analysis behavior at low stress levels through stress-concentrating effect explained influence each factor limits predicted by relationship proposed Murakami good agreement with experimental results.
منابع مشابه
Estimation of Maximum Inclusion Size and Fatigue Limit in HSLA-100 Steel
The objective of the current study is to determine the fatigue limit of a clean and high-performance material named as HSLA-100 steel and to compare the obtained fatigue limit with that of theoretically predicted fatigue limit by statistics of extreme value (SEV) method. Also, the size of inclusions located at the site of fatigue crack nucleation on the fracture surface of the fatigue test spec...
متن کاملStrong Ferritic – Steel Welds
There are many steels which are stronger than 2000 MPa, with toughness values exceeding 100 MPa m and which have been in commercial service for many decades. Examples include the marageing alloys and carbide–free bainitic steels. By contrast, welding consumables with a proof strength in excess of 1000 MPa are few and far between. This is because whereas wrought steels can be thermomechanically ...
متن کاملIdentification of Low Cycle Fatigue Parameters of High Strength Low-alloy (hsla) Steel at Room Temperature
S. Bulatović, Yugoslav River Shipping, Serbia, Lj. Milović, University of Belgrade, Faculty of Technology and Metallurgy, Serbia, A. Sedmak, University of Belgrade, Faculty of Mechanical Engineering, Serbia, I. Samardžić, University of Osijek, Mechanical Engineering Faculty, Slavonski Brod, Croatia Low cycle fatigue test was performed in ambient atmosphere at room temperature. Cycle loading of ...
متن کاملThe Effect of Pre-strain on Fatigue for a High Strength Low Alloy (hsla)steel
D. Aguirre-Guerrero, A. Juárez-Hernández, M.A.L. Hernández-Rodríguez, University Autonumous of Nuevo León, Faculty of Mechanical and Electrical Engineering, Nuevo León, México. R. Morales, I. Ruiz, PEMSA Co. Celaya, Guanajuato, México. The eff ect of initial plastic strain c ycle fatigue lives of HSLA specimens is in vestigated. Specimens were monotonically, quasi-statically loaded under strain...
متن کاملSome Studies on Temperature Distribution Modeling of Laser Butt Welding of AISI 304 Stainless Steel Sheets
In this research work, investigations are carried out on Continuous Wave (CW) Nd:YAG laser welding system after preliminary experimentation to understand the influencing parameters associated with laser welding of AISI 304. The experimental procedure involves a series of laser welding trials on AISI 304 stainless steel sheets with various combinations of process parameters like beam power, beam...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metals
سال: 2021
ISSN: ['2075-4701']
DOI: https://doi.org/10.3390/met11101499