Fatigue Property of Super-Elastic Ti–Ni Alloy Dental Castings
نویسندگان
چکیده
منابع مشابه
Bending Property of Super-Elastic Ti-Ni Alloy Dental Castings with Different Heat Treatments
Bending property of Ti-Ni alloy dental castings was evaluated in comparison with that of Co-Cr alloy in a cantilever test. Heat treatment effect on the bending property was also investigated in relation to phase transformation. Ti-50.85Ni (mol%) alloy was used, and the shape of bending test specimens was half-rounded in cross section, 2.0mm in diameter. The bending test was carried out at 310K....
متن کاملFatigue properties of Ni-43.5%Ti superelastic alloy castings.
To evaluate a Ni-43.5wt%Ti alloy as a new alloy for cast clasp, the fatigue properties of its castings were examined and compared with those of Co-Cr and Type IV Au alloys castings. The Ni-Ti alloy was cast into a phosphate-bonded investment mold using an argon-arc melting and pressure casting machine. The Ni-Ti alloy castings showed superelasticity in bending tests. Fatigue tests were carried ...
متن کاملSurface characteristics and castability of Zr-14Nb alloy dental castings.
The purpose of this study was to evaluate mechanical properties, surface characteristics and castability of Zr-14Nb dental castings. The mean 0.2% proof and ultimate tensile strengths of Zr-14Nb were approximately 68% and 76% those of Ti-6Al-7Nb, respectively, while they were comparable to Co-29Cr-6Mo. Elongation of Zr-14Nb was the highest of all alloys tested. The hardened reaction layer was f...
متن کاملWalker Parameter for Mean Stress Correction in Fatigue Testing of Al-7%Si-Mg Alloy Castings
In this study, performance of two existing Walker parameter estimation models has been investigated. Results show that those developed mainly for steel did not provide reasonable fits to experimental Walker parameters for fatigue data for Al-7%Si-Mg alloy castings in the literature. A strong relationship between the Walker parameter and the structural quality, quantified by the quality index, Q...
متن کاملFeeding of High-Nickel Alloy Castings
Feeding of the nickel-based alloys CZ-100, M-35-1, and CW-12MW, as well as of the austenitic stainless steel CN-7M, is investigated, using a combination of casting experiments and simulation. Casting trials are performed at five foundries, to produce a total of 55 plates of varying lengths and radiographic soundness levels. In order to develop the property databases necessary to simulate the ca...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2005
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.46.1555