Fatigue strength of machined screw thread. Effects of loading modes in fatigue test.
نویسندگان
چکیده
منابع مشابه
Fatigue cyclic loading test of an auro-galvanoforming ceramic bridge.
BACKGROUND In dental clinics, dentition defects are commonly restored with conventional porcelain-fused-to-metal fixed bridges. However, Ni-Cr alloy ceramic fixed bridges are known to have several drawbacks such as marginal coloration of the neck, low casting precision and, most seriously, poor biocompatibility. These problems could be circumvented by using noble metal ceramic bridges; however,...
متن کاملSteering Rod Fatigue Test Bench Cam Loading Analysis
Steering rods are subject to variety kinds of loads which will eventually cause failure. Automobile manufacturers and engineers are seeking ways to test the fatigue life of the steering rods. Steering rods under periodic loads over millions of cycles will get fatigued. We here provide a fatigue test bench for steering rods which applies periodic loads to the rod with a cam loading system. Cyclo...
متن کاملEstimating the fatigue stress concentration factor of machined surfaces
In this study the effects of surface texture on the fatigue life of a high-strength low-alloy steel were evaluated in terms of the apparent fatigue stress concentration. An abrasive waterjet was used to machine uniaxial dogbone fatigue specimens with specific surface quality from a rolled sheet of AISI 4130 CR steel. The surface texture resulting from machining was characterized using contact p...
متن کاملEFFECTS OF TENSILE STRENGTH ON FATIGUE BEHAVIOR AND NOTCH SENSITIVITY OF TI-6AL-4V
In this research, rotating bending fatigue test at minimum to maximum stress ratio of R=-1 was used for investigating the fatigue behavior of Ti-6Al-4V alloy. Both smooth and notched specimens, with elastic concentration factor, kt, of approximately 3.6 and 4.1 were used for this purpose.In addition, the effect of variation in ultimate tensile strength, UTS, on the fatigue behavior of this allo...
متن کاملAssessment of different methods for fatigue life prediction of steel in rotating bending and axial loading
Generally, fatigue failure in an element happens at the notch on a surface where the stress level rises because of the stress concentration effect. The present paper investigates the effect of a notch on the fatigue life of the HSLA100 (high strength low alloy) steel which is widely applicable in the marine industry. Tensile test was conducted on specimens and mechanical properties were obtain...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1987
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.53.2640