Fatigue Testing Methods for Elastomer
نویسندگان
چکیده
منابع مشابه
Fatigue Characterization of 3d Printed Elastomer Material
The Objet PolyJet 3D Printing process provides the ability to print graded materials featuring both stiff and elastomeric polymers. This capability allows for a variety of new design possibilities for additive manufacturing such as living hinges, shock absorbing casings, and integrated gaskets. Such design features typically rely upon the ability of traditional elastomers to experience large an...
متن کاملislanding detection methods for microgrids
امروزه استفاده از منابع انرژی پراکنده کاربرد وسیعی یافته است . اگر چه این منابع بسیاری از مشکلات شبکه را حل می کنند اما زیاد شدن آنها مسائل فراوانی برای سیستم قدرت به همراه دارد . استفاده از میکروشبکه راه حلی است که علاوه بر استفاده از مزایای منابع انرژی پراکنده برخی از مشکلات ایجاد شده توسط آنها را نیز منتفی می کند . همچنین میکروشبکه ها کیفیت برق و قابلیت اطمینان تامین انرژی مشترکان را افزایش ...
15 صفحه اولUsing PCR and culture methods for Mycoplasma testing
Mycoplasma contaminants can be considered important not only for their roles as pathogens but also they may indicate that insufficient care has been taken during vaccine manufacture or quality control. The purpose of this study was to test the poliomyelitis vaccines for Mycoplasma by culture and polymerase chain reaction (PCR) methods. During 2008 to 2009, a total of 47 lots of oral poliomyelit...
متن کاملComparison of two methods of fatigue testing bone cement.
Two different methods have been used to fatigue test four bone cements. Each method has been used previously, but the results have not been compared. The ISO 527-based method tests a minimum of 10 samples over a single stress range in tension only and uses Weibull analysis to calculate the median number of cycles to failure and the Weibull modulus. The ASTM F2118 test regime uses fewer specimen...
متن کاملReiterated tension testing of silicone elastomer
A peristaltically actuated device, PADeMIS, composed of silicone rubber (SR) is under development for use in minimally invasive surgery. During locomotion, the device will be subject to a few thousand load changes involving varying, sometimes high, strains. The design is being optimised by finite element analysis, for which a constitutive law for the mechanical behaviour of silicone rubber is r...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: NIPPON GOMU KYOKAISHI
سال: 2010
ISSN: 0029-022X
DOI: 10.2324/gomu.83.20