Feature Article—Statistical Analysis of Simulation Output Data
نویسندگان
چکیده
منابع مشابه
A Procedure for Building Confidence Interval on the Mean of Simulation Output Data
One of the existing methods to build a confidence interval (c.i.) for the mean response in a single steady state simulation system is the batch means method. This method, compared to the other existing methods (autoregressive representation, regenerative cycles, spectrum analysis, standardized time series), is quite easy to understand and to implement and performs relatively well. However, the ...
متن کاملFeature-based Volume Rendering of Simulation Data
In this paper we present a framework for interactive volume rendering of high-dimensional flow simulation data. Our approach combines information visualization, flow visualization, as well as volume visualization techniques for volumetric flow visualization. Interactive feature specification by use of multiple linked views and composite non-binary brushes enables selection and multiple definiti...
متن کاملEfficiency Measurement of Bank Branches with Undesirable Output Using Non-Radial Models of Data Envelopment Analysis
Today, banks, as intermediaries, seek to attract and allocate resources to obtain greater benefit. Therefore, the bank assessment is considered as an important subject in the banking industry. Data envelopment analysis is an effective technique in evaluating the efficiency of decision-making units. There are factors among banking indices (such as receivables from resource allocation) that are i...
متن کاملThe comparison between 6 MV Primus LINAC simulation output using EGSnrc and commissioning data
Introduction: Monte Carlo calculation method is considered to be the most accurate method for dose calculation in radiotherapy. The purpose of this research is comparison between 6 MV Primus LINAC simulation output with commissioning data using EGSnrc and build a Monte Carlo geometry of 6 MV Primus LINAC as realistically as possible. The BEAMnrc and DOSXYZnrc (EGSnrc package) M...
متن کاملOutput-only Modal Analysis of a Beam Via Frequency Domain Decomposition Method Using Noisy Data
The output data from a structure is the building block for output-only modal analysis. The structure response in the output data, however, is usually contaminated with noise. Naturally, the success of output-only methods in determining the modal parameters of a structure depends on noise level. In this paper, the possibility and accuracy of identifying the modal parameters of a simply supported...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Operations Research
سال: 1983
ISSN: 0030-364X,1526-5463
DOI: 10.1287/opre.31.6.983