FEM Simulation of Cutting Process of Sheet Metals with Wedge Shape Punches.
نویسندگان
چکیده
منابع مشابه
Forming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کامل3D FEM Simulation of Water Vapor Jet Assisted Metal Cutting
Water vapor jet assisted metal cutting is a pollution-free green cutting technique. This paper has developed a three-dimensional finite element model of water vapor jet assisted cutting in order to understand the influence of its cooling and lubricating effect on cutting process. The cooling effect of water vapor jet is modeled with a convective heat transfer coefficient. A window with the temp...
متن کاملThe Analysis and Simulation for Improved Cutting Process based on Finite Element Method (FEM) Analysis
The paper proposed the practical metal cutting process using FEM to simulate the traditional cutting process, the simulation and the analysis of the results are based on the support of DEFORM3D finite element software, and the characteristic between Galerkin Algorithm and FEM analysis is also analyzed. Then the paper processed the modeling procedure for FEM using Lagrange and Euler algorithm, t...
متن کاملSimulation of Kinetic Friction in L-Bending of Sheet Metals
This paper aims at experimental and numerical investigation of springback behavior of sheet metals during Lbending process with emphasis on Stribeck-type friction modeling. The coefficient of friction in Stribeck curve depends on sliding velocity and contact pressure. The springback behavior of mild steel and aluminum alloy 6022-T4 sheets was studied experimentally and using numerical simulatio...
متن کاملSimulation of Cutting Process in Turning
This paper presents simulation of cutting process by turning of polyamide PA 66, the simulation based on approach Arbitrary Lagrangian Eulerian, ALE. Was taken into account a tool knife CNMA from Coromant. The flow stress of the workpiece is modeled as function of strain, strain rate and temperature, so as to reflect its dynamic changes in physical properties. In this way, the influences of dep...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 2002
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.68.1303