Femtosecond-Laser-Induced Surface Texturing of Al-Si Alloy for Lower Friction Surface
نویسندگان
چکیده
منابع مشابه
Femtosecond Laser-induced Surface Texturing and Crystallization of A-si:h Thin Film
Hydrogenated amorphous silicon (a-Si:H) thin films have been considered for use in solar cell applications because of their significantly reduced cost, however, the overall efficiency and stability are less than that of their bulk crystalline counterparts. Limited work has been performed on solving the efficiency and stability issues of a-Si:H simultaneously. In this study, both surface texturi...
متن کاملINFLUENCE OF LASER SURFACE HARDENING ON CORROSION PROPERTIES OF Al-Zn-Si CAST ALLOY
E. Tillová, L. Kuchariková, M. Chalupová, J. Belan, A. Vaško, I. Švecová, University of Žilina, Faculty of Mechanical Engineering, Slovak Republic This work is focused on the effect of the laser surface treatment (laser power 50 and 80 W) on microstructure and corrosion properties of self-hardened AlZn10Si8Mg cast alloy used for engine and vehicle constructions. The electrochemical impedance sp...
متن کاملFemtosecond laser induced surface nanostructures on copper
This study demonstrated circular surface nanostructures and femtosecond laser-induced periodic surface structures (FLIPSS) for copper produced by a Ti:Sapphire femtosecond laser beam of wavelength 800 nm and duration 120 fs. The circular textured nanostrucres could be created by a single laser pulse. The nanostructures in the center of the heated spot diminish as laser fluence increases and a c...
متن کاملEffect of surface texturing by femtosecond laser on tantalum carbide ceramics for solar receiver applications
Tantalum carbide, as a Ultra-High Temperature Ceramic, is known to be characterized by intrinsic spectral selectivity, which makes it attractive for novel high-temperature thermal solar absorbers. However, a weakness point of TaC is the solar absorbance, which, in absence of any treatment, is usually lower than that of other materials currently under development for solar absorber applications....
متن کاملOptimum dimple diameter for friction reduction with laser surface texturing: the effect of velocity gradient
This paper describes the modelling and testing of mm-scale hydrodynamic bearings which are being developed to improve the efficiency of a cm-scale turbine energy harvester, whose efficiency was previously limited by poorly lubricated commercial jewel-bearings. The bearings were fabricated using DRIE and their performance was assessed using a custom built MEMS tribometer. Results demonstrate tha...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Review of Laser Engineering
سال: 2014
ISSN: 0387-0200,1349-6603
DOI: 10.2184/lsj.42.4_341