Ferromagnetism in SnO<sub>2</sub> by Mechanical Milling
نویسندگان
چکیده
منابع مشابه
DISORDERING OF FeAl BY MECHANICAL MILLING
Point defect concentrations in milled samples of stoichiometric FeAl were obtained by Mssbauer measurements. Mssbauer spectra consisted of a single absorption dip with broadening attributed to unresolved hyperfine interactions. A local environment model was used to analyze spectra that allowed for defect-induced changes in monopole interactions at Fe probe atoms due to elementary defects in t...
متن کاملHydrogen evolution activity of NiMo-MoO2 produced by mechanical milling
In this study, mechanical alloying was done by a high-energy planetary ball milling technique. A mixture of NiO and MoO3 and graphite powders were used as initial materials. After milling of powder mixture with 40 wt.% additional graphite, a temperature of 400, 550 and 1000 °C for 1 h was considered for the heat treatment of powder mixture. Also, powder mixtures containing 60, 80 and 100 wt.% a...
متن کاملMechanical milling of aluminum powder using planetary ball milling process
Mechanical alloying has recently attracted considerable attention as researchers strive to enhance nanocomposite properties and extend their utility. The process can be performed at room temperature and homogeneous nanocomposite powders can be produced. In this paper, we investigated the effect of different ball milling parameters and operating conditions (milling time, ball size, processing co...
متن کاملMechanical milling of the intermetallic compound AlFe
The intermetallic compound AlFe in its ordered B2 phase has been ground under Ar in a ball-milling device. The system evolution under mechanical work has been examined as a function of time of milling by x-ray diffraction, transmission Mössbauer spectroscopy, and differential scanning calorimetry. Short and long range disorder was observed. The evolution of the long range order parameter with m...
متن کاملFabrication of Nanostructured Cu matrix Nanocomposites by High Energy Mechanical Milling and Spark Plasma Sintering
Spark plasma sintering (SPS) is a sintering process that is capable of sintering hard worked powders in short times. This technique was used to fabricate bulk Cu and Cu-SiC nanocomposites. Pure Cu and mixed powders of Cu including 4 vol% of SiC nanoparticles were mechanically alloyed for 25 h and sintered at 750˚C under vacuum condition by SPS method. Microstructures of the materials were chara...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Materials Research Society of Japan
سال: 2013
ISSN: 1382-3469,2188-1650
DOI: 10.14723/tmrsj.38.389