Fiber push-in failure in carbon fiber epoxy composites
نویسندگان
چکیده
منابع مشابه
The Durability of Carbon Fiber/Epoxy Composites under Hydrothermal Ageing
Studies on fibre reinforced composites are now receiving greater attention. Industrial applications have been successful in areas like aerospace, automobile, marine, construction and sporting goods. The first generation of epoxy resins for use in carbon fibre composites are able to achieve optimized high stiffness modules and high heat resistance by a high crosslink density, reached through the...
متن کاملNonlinear Ultrasounic Resonance Spectroscopy of Intact Carbon Fiber/Epoxy Composites
The present study reports the influence of fiber orientation, laminate sequence and fabric type on the inherent nonlinearity of intact carbon fiber/epoxy composites using nonlinear resonant ultrasonic spectroscopy (NRUS) [1-2]. Fiber orientation of the CFRP samples were changed relative to the length of the sample. Since the fundamental flexural mode is excited, the properties of the composite ...
متن کاملCreep Behavior of Basalt and Glass Fiber Reinforced Epoxy Composites
The creep behavior of basalt fiber reinforced epoxy (BFRE) and glass fiber reinforced epoxy (GFRE) composites was studied through tensile testing at high temperature. To study the effect of reinforcing epoxy, the micro glass powder (MGP) was added at various volume percentage into the epoxy resin in BFRE composites. The initial strain for all the specimens were evaluated and compared with each ...
متن کاملEffect of Epoxy Functional Groups on the Properties of Carbon Fiber-Epoxy Composites
Matrix resins of carbon fiber-epoxy composites with different numbers of epoxy functional groups were prepared, and their properties were compared to optimize the matrix resin composition. To understand the bonding strengths between the carbon fiber and epoxy resins in monofilaments and micro-sized resin beads, the interfacial shear strength (IFSS) was measured using the microdroplet technique....
متن کاملFiber Orientation in Injection Molded Long Carbon Fiber Thermoplastic Composites
A set of edge-gated and center-gated plaques were injection molded with long carbon fiber-reinforced thermoplastic composites, and the fiber orientation was measured at different locations of the plaques. Autodesk Simulation Moldflow Insight (ASMI) software was used to simulate the injection molding of these plaques and to predict the fiber orientation, using the Anisotropic Rotary Diffusion an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Structural Integrity
سال: 2020
ISSN: 2452-3216
DOI: 10.1016/j.prostr.2020.10.063