Filler in Rubber Compound.
نویسندگان
چکیده
منابع مشابه
Fabrication of Wood-Rubber Composites Using Rubber Compound as a Bonding Agent Instead of Adhesives
Differing from the hot-pressing method in the manufacturing of traditional wood-rubber composites (WRCs), this study was aimed at fabricating WRCs using rubber processing to improve water resistance and mechanical properties. Three steps were used to make WRCs, namely, fiber-rubber mixing, tabletting, and the vulcanization molding process. Ninety-six WRC panels were made with wood fiber content...
متن کاملRubber friction for tire tread compound on road surfaces.
We have measured the surface topography and calculated the surface roughness power spectrum for an asphalt road surface. For the same surface we have measured the friction for a tire tread compound for velocities 10(-6) m s(-1) < v < 10(-3) m s(-1) at three different temperatures (at -8 °C, 20 °C and 48 °C). The friction data was shifted using the bulk viscoelasticity shift factor a(T) to form ...
متن کاملRubber materials from elastomers and nanocellulose powders: filler dispersion and mechanical reinforcement.
Rubber materials with well-dispersed fillers and large mechanical reinforcement have been obtained by melt-processing a diene elastomer matrix and tailored nanocellulose powders having both a high specific surface area and a modified interface. Such filler powders with a specific surface area of 180 m2 g-1 and 100 m2 g-1 have been obtained by freeze-drying suspensions of short needle-like cellu...
متن کاملSurvey of Micro/nano Filler Use to Improve Silicone Rubber for Outdoor Insulators
Among the new insulating materials widely used in high-voltage outdoor insulation, silicone rubber has received the most attention. Indeed, silicone rubbers are gaining in popularity as an effective counter-measure to insulator contamination problems. However, pure silicone rubber shows little tracking and erosion resistance. So, some properties of silicone rubber need to be improved to extend ...
متن کاملInfluence of Crystallization and Filler Degree on Viscoelastic Properties of Rubber Compounds
The dimensioning of injection heads for the extrusion of rubber profiles is exclusively based on empiric knowledge of the non-linear flow behavior of elastomers. Thus, the design of injection heads is carried out with subject to the used rubber compound, whereas the geometry of the appropriate profile is achieved by empiric adaptation of the extrusion die. This was one of the motivations for a ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: NIPPON GOMU KYOKAISHI
سال: 1998
ISSN: 1884-0442,0029-022X
DOI: 10.2324/gomu.71.583