Filmwise Condensation Heat Transfer between Parallel Flow Channels
نویسندگان
چکیده
منابع مشابه
Flow condensation in parallel micro-channels – Part 2: Heat transfer results and correlation technique
This second part of a two-part study concerns heat transfer characteristics for FC-72 condensing along parallel, square micro-channels with a hydraulic diameter of 1 mm, which were formed in the top surface of a solid copper plate. Heat from the condensing flow was rejected to a counter flow of water through channels brazed to the underside of the copper plate. The FC-72 condensation heat trans...
متن کاملFlow and Heat Transfer Analysis of the Sodium Alginate Conveying Copper Nanoparticles between Two Parallel Plates
In this study, the steady incompressible flow of a non-Newtonian sodium alginate (SA) fluid conveying copper nanoparticles (Cu) which flow within two vertical parallel plates is investigated by using the homotopy perturbation analytical scheme to solve the coupled nonlinear ordinary equations arising from the mechanics of the fluid. The developed analytical solutions are used to investigate the...
متن کاملPerturbation-Iteration Algorithm for Solving Heat and Mass Transfer in the Unsteady Squeezing Flow between Parallel Plates
In this paper, heat and mass transfer in the unsteady squeezing flow between parallel plates is analyzed using a perturbation-iteration algorithm. The similarity transformation is used to transform the governing partial differential equations into ordinary differential equations, before being solved. The solutions of the velocity, temperature and concentration are derived and sketched to explai...
متن کاملModeling heat and mass transfer in laminar forced flow between parallel plates channel imposed to suction or injection
A numerical model is developed to simulate the transport phenomena in the flow channel between parallel plates with porous and non-porous (or impermeable) walls. The continuity and momentum equations were solved first, assuming the wall Reynolds number in the range of with the suction or injection of air at a speed equal to the uniform inlet velocity. The results show that at constant inlet and...
متن کاملAn approximate model for slug flow heat transfer in channels of arbitrary cross section
In this paper, a novel approximate solution to determine the Nusselt number for thermally developed, slug (low-prandtl), laminar, single phase flow in channels of arbitrary cross section is presented. Using the Saint-Venant principle in torsion of beams, it is shown that the thermally developed Nusselt number for low-prandtl flow is only a function of the geometrical parameters of the channel c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 1982
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.48.308