FINE PATTERN FABRICATION USING FREON GAS PLASMA ETCHING
نویسندگان
چکیده
منابع مشابه
Graphene Nanoribbon Array Fabrication by Oxygen Gas Plasma Etching through Sub-micrometer Porous Filters
We investigate a novel method of fabricating a network of graphene nanoribbon structures. The process is a sharp departure from conventional nanolithographic techniques in both method and amount of time required. Epitaxial graphene prepared on single crystal 4H-SiC(0001) was etched with O2 plasma through 0.2 μm porous filters adhered to the surface of the sample. Thickness measurements using el...
متن کاملFabrication of MEMS devices by using anhydrous HF gas-phase etching with alcoholic vapor
In silicon surface micromachining, anhydrous HF GPE process was verified as a very effective method for the dry release of microstructures. The developed gas-phase etching (GPE) process with anhydrous hydrogen fluoride (HF) gas and alcoholic vapor such as methanol, isopropyl alcohol (IPA) was characterized and its selective etching properties were discussed. The structural layers are P-doped mu...
متن کاملDesign and Fabrication of MEMS Micropumps using Double Sided Etching
In this paper, we report a simple technique for the fabrication of planar valveless micropumps. The technique utilizes MEMS fabrication methods by using a double sided etch technique. Instead of using several masks and process steps, an anisotropic wet etch technique at both sides of a silicon substrate is implemented at the same time for creating the pump membrane and the diffuser/ nozzle elem...
متن کاملRemote plasma etching of silicon nitride and silicon dioxide using NF3/O2 gas mixtures
The etching of silicon nitride (Si3N4) and silicon dioxide (SiO2) in the afterglow of NF3 and NF3 /O2 microwave discharges has been characterized. The etch rates of both materials increase approximately linearly with the flow of NF3 due to the increased availability of F atoms. The etch rate of Si3N4 is enhanced significantly upon O2 injection into the NF3 discharge for O2 /NF3 ratios of 0.3 an...
متن کاملDesign, fabrication and characterization of a novel gas microvalve using micro- and fine-machining
In this paper, we present the design, fabrication and characterization of a novel gas microvalve realized by combining microand fine-machining techniques. The design is for high flow rates at high pressure difference between inlet and outlet, burst pressure of up to 15 bars. There is no power consumption required for the valve to maintain its position during operation in any intermediate state ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Precision Engineering
سال: 1976
ISSN: 0374-3543
DOI: 10.2493/jjspe1933.42.485