Finite Element Analysis (FEA) for the Beam-Column Joint Subjected to Cyclic Loading Was Performed Using ANSYS
نویسندگان
چکیده
منابع مشابه
Finite element analysis of a rigid beam to column connection reinforced with channels
Abstract: This research work presents a new rigid connection constructed with channels. In order to assess its hysteresis behavior, three specimens with different cover plates and six specimens with different panel zone thickness have been considered. The energy absorbed by the connection and the behavior of the panel zone were studied during cyclic loading and compared with those of connectio...
متن کاملA Macroscopic Finite Element for a Symmetric Double Lap Joint Subjected to Mechanical and Thermal Loading
A thermo-mechanical analytical model and a corresponding macroscopic bonded joint finite element is presented for the analysis of orthotropic double lap joints subjected to combined thermal-mechanical loads. The analytical solution offers an improvement in accuracy over its predecessor, at the cost of increased solution complexity. However, to facilitate the use of this solution, it has been in...
متن کاملFinite Element Analysis for CFST Columns under Blast Loading
The columns of frame structures are the key load-bearing components and the exterior columns are susceptible to attack in terrorist blasts. When subjected to blast loads, the columns would suffer a loss of bearing capacity to a certain extent due to the damage imparted which may lead to their collapse and even cause the progressive collapse of the whole structure . The concrete-filled steel col...
متن کاملConcrete Filled Tubular Bracing Subjected to Cyclic Loading
The energy absorption of concrete filled, hollow-steel bracing was analyzed respect to geometric and mechanical parameters including the width-to-thickness section ratio, slenderness level, and strength of the steel and concrete. Local buckling and ductility were also investigated with respect to variation in the cross-section. The infill increased the compression resistance, even after multipl...
متن کاملFinite element analysis (FEA) modeling on adhesive joint for composite fuselage model
In this paper, a finite element modeling via ABAQUS/Explicit simulation on a novel fabrication miniature composite fuselage structure is presented. The fuselage structure is modeled as a continuum composite layup that consisted of a woven C-glass fiber/epoxy 200 g/m 2 composite laminated [908] with the orthotropic elastic material properties and adhesively bonded butt joint. The adhesively bond...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Circuits and Systems
سال: 2016
ISSN: 2153-1285,2153-1293
DOI: 10.4236/cs.2016.78138