Finite Element Modeling of Tower Bolt Connection and Dynamic Load Analysis
نویسندگان
چکیده
منابع مشابه
Dynamic Load Carrying Capacity of Flexible Manipulators Using Finite Element Method and Pontryagin’s Minimum Principle
In this paper, finding Dynamic Load Carrying Capacity (DLCC) of flexible link manipulators in point to-point motion was formulated as an optimal control problem. The finite element method was employed for modelling and deriving the dynamic equations of the system. The study employed indirect solution of optimal control for system motion planning. Due to offline nature of the method, many diffic...
متن کاملFinite element analysis of a rigid beam to column connection reinforced with channels
Abstract: This research work presents a new rigid connection constructed with channels. In order to assess its hysteresis behavior, three specimens with different cover plates and six specimens with different panel zone thickness have been considered. The energy absorbed by the connection and the behavior of the panel zone were studied during cyclic loading and compared with those of connectio...
متن کاملMaximum Allowable Dynamic Load of Flexible 2-Link Mobile Manipulators Using Finite Element Approach
In this paper a general formulation for finding the maximum allowable dynamic load (MADL) of flexible link mobile manipulators is presented. The main constraints used for the algorithm presented are the actuator torque capacity and the limited error bound for the end-effector during motion on the given trajectory. The precision constraint is taken into account with two boundary lines in plane w...
متن کاملA Proposed Modeling Method in Finite Element Slope Stability Analysis
Limit-equilibrium method (LEM) and finite element method (FEM) with strength reduction method (SRM) techniques are the most widely used analysis tools in slope stability assessment. Recently, researchers have reported that both factor of safety (FOS) values and failure surfaces obtained from LEM and FEM are generally in good agreement, except in some particular cases. In this paper, the FOS and...
متن کاملdynamic load carrying capacity of flexible manipulators using finite element method and pontryagin’s minimum principle
in this paper, finding dynamic load carrying capacity (dlcc) of flexible link manipulators in point to-point motion was formulated as an optimal control problem. the finite element method was employed for modelling and deriving the dynamic equations of the system. the study employed indirect solution of optimal control for system motion planning. due to offline nature of the method, many diffic...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mechanical Engineering and Technology
سال: 2017
ISSN: 2167-6631,2167-6623
DOI: 10.12677/met.2017.62013