Finite Element Simulation of a Flexible Manipulator-Part 2: Parallel Processing Techniques
نویسندگان
چکیده
منابع مشابه
SIMULATION OF NICKEL ELECTROFORMING PROCESS OF A REVOLVING PART USING FINITE ELEMENT METHOD
n this paper a finite element model has been proposed for evaluation of primary and secondary current density values on the cathode surface in nickel electroplating operation of a revolving part. In addition, the capability of presented electroplating simulation has been investigated in order to describe the electroplated thickness of the nickel sulfate solution. Nickel electroplating experi...
متن کاملMaximum Allowable Dynamic Load of Flexible 2-Link Mobile Manipulators Using Finite Element Approach
In this paper a general formulation for finding the maximum allowable dynamic load (MADL) of flexible link mobile manipulators is presented. The main constraints used for the algorithm presented are the actuator torque capacity and the limited error bound for the end-effector during motion on the given trajectory. The precision constraint is taken into account with two boundary lines in plane w...
متن کاملA nonlinear feedback controller for a single-link flexible manipulator based on a finite element model
In this article, a nonlinear dynamic model of a flexible manipulator is derived through finite element method associated with Lagrange approach. The flexible manipulator is modeled as an Euler–Bernoulli beam driven by a motor at its base and with a point mass tip payload. The generalized coordinates of the system are selected to be the displacements and rotations of the nodes on the considered ...
متن کاملAccurate Modeling and Nonlinear Finite Element Analysis of a Flexible-Link Manipulator
Accurate dynamic modeling and analysis of flexible link manipulator (FLM) with non linear dynamics is very difficult due to distributed link flexibility and few studies have been conducted based on assumed modes method (AMM) and finite element models. In this paper a nonlinear dynamic model with first two elastic modes is derived using combined Euler/Lagrange and AMM approaches. Significant dyn...
متن کاملA Review of Application of Signal Processing Techniques for Fault Diagnosis of Induction Motors – Part I
Abstract - Use of efficient signal processing tools (SPTs) to extract proper indices for fault detection in induction motors (IMs) is the essential part of any fault recognition procedure. The Part1 of the two parts paper focuses on Fourier-based techniques including fast Fourier transform and short time Fourier transform. In this paper, all utilized SPTs which have been employed for fault fete...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Low Frequency Noise, Vibration and Active Control
سال: 1999
ISSN: 1461-3484,2048-4046
DOI: 10.1177/026309239901800305