FIR Filter Design Using Distributed Maximal Flatness Method
نویسندگان
چکیده
منابع مشابه
Design of FIR Filter using Distributed Arithmetic Architecture
--Digital filters can be realized in hardware, software. In general digital filters tend to be more expensive than analog filters.But digital filters can be used to implement complex applications that analog filters cannot. This paper presents the design of a double-precision lowpass direct form Finite Impulse Response (FIR) filter to meet the given specification. Simulation results have been p...
متن کاملAdaptive FIR Filter Using Distributed Airthmetic for Area Efficient Design
In this paper we propose an efficient pipelined architecture for low power,high throughput and low area adaptive FIR filter based on distributed airthemetic. The throughput rate is significantly increased by parallel look-up table(LUT) update. Reduction in power consumption is achieved by using a fast bit clock for carry save accumulation. We have shown that sampling period could be sequentiall...
متن کاملDistributed Arithmetic Unit Design for Fir Filter
In this paper different distributed Arithmetic (DA) architectures are proposed for Finite Impulse Response (FIR) filter. FIR filter is the main part of the Digital Signal Processing. In Digital Signal Processing we can use Multiply Accumulator Circuit (MAC) and DA for filter design.MAC consumes more power and area because of multiplier and adder circuit. The design distributed arithmetic is run...
متن کاملDesign of FIR Filter Using Hamming Window
Digital filters are pervasive in the present era of communication systems. As a result good digital filter performance is important and hence to design a digital finite impulse response (FIR) filter satisfying all the required condition is a demanding one. This report deals with the design of FIR digital filter using hamming window technique. This window is optimized to minimize the maximum (ne...
متن کاملAn Efficient Method for Narrowband FIR Filter Design
A new efficient method for implementing narrowband FlR jilters is presented. The method is based on an lnterpolated jilter (lFlR) structure and a cascade of comb and integrator (ClC) structures. The novelty ofthís technique ís that the ClC structure is used as an image suppressor in an lFlR structure. The method is useful for narrowband FlRjilter design and some design examples for lowpass and ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Electronics and Telecommunications
سال: 2013
ISSN: 0867-6747
DOI: 10.2478/eletel-2013-0007