FLOW BEHAVIOUR AND MICROSTRUCTURAL EVOLUTION OF TITANIUM Ti-10V-2Fe-3Al ALLOY DURING HOT COMPRESSION TEST
نویسندگان
چکیده
منابع مشابه
Numerical Descriptions of Hot Flow Behaviors across Transus for as-Forged Ti–10V–2Fe–3Al Alloy by LHS-SVR and GA-SVR and Improvement in Forming Simulation Accuracy
Guo-Zheng Quan 1,*, Zhi-Hua Zhang 1, Le Zhang 1 and Qing Liu 2 1 State Key Laboratory of Mechanical Transmission, School of Material Science and Engineering, Chongqing University, Chongqing 400044, China; [email protected] (Z.-H.Z.); [email protected] (L.Z.) 2 China National Erzhong Group Co., Deyang 618000, Sichuan, China; [email protected] * Correspondence: [email protected]; Tel./Fa...
متن کاملMicrostructural Evaluation of Ti-6AL-4V Alloy during Hot Deformation
Among the titanium alloys, Ti-6Al-4V is the most widely used. In the present work, the uniaxial hot compressive behavior of Ti-6Al-4V has been investigated under constant strain rates. A series of dilatometery experiments were carried out to determine the transformation temperatures at different cooling rates. Specimens were homogenized at 1050 °C for 10 minutes followed by fast cooling to dif...
متن کاملMicrostructural Evaluation of Ti-6AL-4V Alloy during Hot Deformation
Among the titanium alloys, Ti-6Al-4V is the most widely used. In the present work, the uniaxial hot compressive behavior of Ti-6Al-4V has been investigated under constant strain rates. A series of dilatometery experiments were carried out to determine the transformation temperatures at different cooling rates. Specimens were homogenized at 1050 °C for 10 minutes followed by fast cooling to dif...
متن کاملMechanical properties and microstructural evolution of vacuum hot-pressed titanium and Ti-6Al-7Nb alloy.
Hot-pressing is a powder metallurgy process where loose powder is loaded into a mould, usually of graphite, and sintered by the simultaneous application of high temperature and pressure. In this study elemental titanium and Ti-6Al-7Nb alloy powders are hot-pressed under different conditions in order to study the influence of the processing parameters on the microstructure and mechanical propert...
متن کاملa study of the flow behaviour of a nb-v-ti microalloyed steel during hot compression test
the flow stress of steel depends significantly on microstructural changes taken place during hot deformation processes. in hot deformation processes, the flow stress of steel is influenced by two main metallurgical phenomena, i.e. recovery and recrystallization, along with its chemical composition and thermo-mechanical parameters. the final mechanical properties of steel are also determined by ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The International Conference on Applied Mechanics and Mechanical Engineering
سال: 2012
ISSN: 2636-4360
DOI: 10.21608/amme.2012.36942