Flow characteristics of carbon fibre moulding compounds
نویسندگان
چکیده
منابع مشابه
The effect of powder characteristics on pressure sensitivity of powder injection moulding compounds
Pressure effect on the rheological behaviour of powder-polymer compounds intended for powder injection moulding was determined. A single-piston capillary rheometer modified by addition of a second chamber with a restricting needle valve generating backpressure increasing the pressure in the melted material during the flow through the die was employed to determine pressure sensitivity coefficien...
متن کاملModelling of Tensile Behaviour of Sheet Moulding Compounds
An original approach to compute the longitudinal tensile break stress of multiphase composite materials with short fibers reinforcement is presented. The most obvious mechanical model which reflects a multiphase composite material is a pre-impregnated material, known as prepreg. We may include in this class of prepregs, Sheet-and Bulk Moulding Compounds. The model is seen as consisting of three...
متن کاملHarmfulness of Moulding Sands with Bentonite and Lustrous Carbon Carriers
M. Holtzer, B. Grabowska, S. Żymankowska-kumon, D. Kwaśniew skakrólikowska, R. Dańko, W. Solarski, A. Bobrowski, AGH University of Science and Technology, Faculty of Foundry Engineering, Kraków, Poland Procedures have been developed to determine the volume, rate and composition (particularly BTEX: benzene, toluene, ethylbenzene and xylenes and PAHs (polycyclic aromatic hydrocarbons)) of gas evo...
متن کاملFriction of carbon fibre tows
The fundamental frictional behaviour of carbon fibre tows relevant to composite fabric forming is explored. Tow-on-tool and tow-on-tow contact are considered. For tow-on-tool contact, an experiment is devised to simultaneously observe the true filament contact length and measure the friction force over a range of normal loads. Filament contact length is not constant, as would be given from an i...
متن کاملPotentiality of Optical Fibre Bragg Grating Sensors for Resin Transfer Moulding Process Monitoring
Resin transfer moulding (RTM) is a widely used process for manufacturing composite parts. It is currently gaining market shares compared to autoclave process in particular for high performance applications, such as aerospace, thanks to its higher versatility permitting the manufacturing of complex and high quality composite parts in fairly short cycle times. The major disadvantage of RTM remain...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Composites Part A: Applied Science and Manufacturing
سال: 2016
ISSN: 1359-835X
DOI: 10.1016/j.compositesa.2016.06.020