Flow rate of flux for submerged are welding from conical hoppers.

Gravity Flow of Granular Materials in Conical Hoppers

This paper presents an approximate solution to the flow of a cohesionless granular material in a conical hopper. This is a problem which has received considerable attention in the past though much of the work was directed toward developing an empirical relation of the mass flow rate from experimental data (for example (1,211. In the early 1960's Jenike and Johanson [23] applied the basic princi...

Development Of Cost Effective Agglomerated Fluxes From Waste Flux Dust For Submerged Arc Welding

Submerged arc welding contributes to approximately 10% of the total welding. Approximately 10% -15% of the flux gets converted into very fine particles termed as flux dust before and after welding, due to transportation and handling. If welding is performed without removing these very fine particles from the flux, the gases generated during welding are not able to escape, thus it may result int...

Numerical Determination of Flow Corrective Inserts for Granular Materials in Conical Hoppers*

Submerged Arc Welding: A Review

In industries and research organizations most widely used welding methods are shield metal arc welding (SMAW), gas metal arc welding (GMAW), gas tungsten arc welding (GTAW) and submerged arc welding (SAW). The SAW process is often preferred because it offers high production rate, high melting efficiency, ease of automation and low operator skill requirement. This review will be very helpful for...

Thermaltransport Phenomenon of Submerged Arc Welding Process

Original scientific paper In present work, thermal transport considering heat radiation by oval heat source shape and heat transfer of molten moving electrode was presented. In present paper, an analytical solution was presented by aggregating temperature increments caused by applying liquid metal and heat radiation of moving electrode. The assumptions for the study were heat source of temperat...