Flow Stress Measurement Considering Plastic Anisotropy of Steels
نویسندگان
چکیده
منابع مشابه
triaxiality factor and lode angle effects on failure of a steel considering plastic anisotropy
x-100 steel is one of the most recently developed materials for production of gas transportation pipelines. this material is severely anisotropic. smooth and notched round bars with different notch radius and flat notched specimens with different notch radius and notch depth in tension are tested to characterize the failure of this material under quasi-static loading condition. triaxiality fact...
متن کاملNumerical Study of the Effect of Materials’ Plastic Behavior on Equibiaxial Residual Stress Measurement Using Indentation
Indentation is a new method for estimating residual stress. The plastic behavior of the materials under study can affect indentation parameters and, thus, influences the results of residual stress measurement. In this paper, the effect of yield stress and work-hardening exponent on the accuracy of residual stress measurements in steels and aluminums was studied. Results showed that, for m...
متن کاملMechanical Anisotropy in Steels for Pipelines
There has been a huge expansion in the laying of pipelines for the transmission of fossil fuels over large distances and in dire environments. One particular problem associated with the steels used to fabricate the pipes is that of the anisotropy of mechanical properties, especially the toughness. This review represents an attempt to critically assess the steels and the orientation dependence o...
متن کاملPlastic strain due to twinning in austenitic TWIP steels
Twinning induced plasticity steels are austenitic alloys in which mechanical twinning is a prominent deformation mode, and which exhibit exceptional combinations of ductility, work hardening and ultimate strength. The authors develop in the present paper a crystallographic theory to enable the quantitative investigation of the role of mechanical twinning in enhancing the properties of these all...
متن کاملMeasurement of third-order elastic constants and stress dependent coefficients for steels
Background: There has been little discussion of the third-order elastic constants of steels in the literature until now. In this study, the precise secondand third-order elastic constants of polycrystalline steels were measured under adiabatic and isothermal conditions. Method: Tomeasure theminute change in the propagation time of the elastic wave corresponding to the tensile stress, the unifor...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Technology of Plasticity
سال: 2013
ISSN: 0038-1586,1882-0166
DOI: 10.9773/sosei.54.841