Flue Gas Treatment of Desulphurization Wastewater
نویسندگان
چکیده
منابع مشابه
Dynamics of wet flue gas desulphurization in spray absorber
A concise one dimensional thermal-hydraulic two-fluid model is presented for the numerical prediction of sulphur dioxide absorption from the flue gas onto drops of the water-limestone slurry in the vertical spray tower absorber. The model is based on mass, momentum and energy balance equations for each phase separately, i.e. downward falling droplets of water-limestone slurry and upward flowing...
متن کاملInvestigation of Parameters Affecting Gypsum Dewatering Properties in a Wet Flue Gas Desulphurization Pilot Plant
Wet flue gas desulphurization (FGD) plants with forced oxidation, installed at coal and oil fired power plants for removal of SO2(g), must produce gypsum of high quality. However, quality issues such as an excessive moisture content, due to poor gypsum dewatering properties, may occur from time to time. In this work, the particle size distribution, morphology, and filtration rate of wet FGD gyp...
متن کاملFlue gas treatment for CO2 capture
This report is in two sections: the first describes the flue gas and its treatment in post-combustion capture and the second covers the flue gas in oxyfuel combustion capture. The main components of the flue gas in pulverised coal combustion for postcombustion capture are CO2, N2, O2 and H2O, and air pollutants such as SOx, NOx, particulates, HCl, HF, mercury as well as other contaminants. The ...
متن کاملFlue Gas Conditioning
Flue gas conditioning (FGC) systems offer an effective option for control of Particulate Matter (PM) emissions and enhances the performance of the Electrostatic Precipitators (EPs) when using coal of different properties. The increasing environmental awareness and the mandate of the Environmental Protection Agencies (EPA) in various countries to thermal power stations using coal-fired boilers f...
متن کاملFlue Gas Cooling
When waste heat is not utilized, cooling of flue gases in special cooling chambers becomes necessary, if the dust':'collecting and associated equipment is constructed of metal. The two most common methods of cooling are by dilution with ambient air, and by evaporation of water in the gas stream. Usually, they are combined. Load sharing depends largely on acceptable visibility of stack effluvia ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Earth and Environmental Science
سال: 2021
ISSN: 1755-1315
DOI: 10.1088/1755-1315/634/1/012022