Fluorination of rubber surface with direct current plasma CVD.
نویسندگان
چکیده
منابع مشابه
Low Temperature Plasma CVD Grown Graphene by Microwave Surface-Wave Plasma CVD Using Camphor Precursor
Hydrocarbon precursor such as methane has been widely used to grow graphene films and the methods of growing quality graphene films are dominated by thermal CVD (chemical vapor deposition) system. Graphene films grown by plasma process are generally highly defective which in turns degrade the quality of the films. Here, using a green precursor, camphor we demonstrate a simple and economical met...
متن کاملCharacteristics of hydrophobicity loss on silicone rubber surface during a dynamic drop test with direct current voltage application
Dynamic drop test for studying the temporal lowering of hydrophobicity on the surface of silicone rubber with direct current voltage application was carried out. In this study, we evaluated the influence of the temporal lowering of hydrophobicity under various conductivities and dropping rates for water droplets. As a result, it was found that the dropping rate and the conductivity of water dro...
متن کاملLow-pressure CVD and Plasma- Enhanced CVD
LPCVD is a process used in the manufacturing of the deposition of thin films on semiconductors usually ranging from a few nanometers to many micrometers. LPCVD is used to deposit a wide range of possible film compositions with good conformal step coverage. These films include a variety of materials including polysilicon for gate contacts, thick oxides used for isolation, doped oxides for global...
متن کاملTorque Control of Brushless Direct Current Motor Drives Using Single Current Sensor with High Reliability
Due to the simple structure, high torque density, low maintenance, and high efficiency, brushless direct current (BLDC) motors are widely used in automation and industrial applications. A control strategy based on single current sensor is proposed for a four-switch three-phase BLDC motor system to lower cost and improve reliability. The whole working process of the BLDC motor is divided into si...
متن کاملSurface Modification of Direct-Current and Radio-Frequency Oxygen Plasma Treatments Enhance Cell Biocompatibility
The sand-blasting and acid etching (SLA) method can fabricate a rough topography for mechanical fixation and long-term stability of titanium implant, but can not achieve early bone healing. This study used two kinds of plasma treatments (Direct-Current and Radio-Frequency plasma) to modify the SLA-treated surface. The modification of plasma treatments creates respective power range and differen...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: NIPPON GOMU KYOKAISHI
سال: 1993
ISSN: 1884-0442,0029-022X
DOI: 10.2324/gomu.66.102