Flying hot-wire system with reciprocating motion of sensor.
نویسندگان
چکیده
منابع مشابه
Flying Hot Potatoes
Optical communication networks and air traffic management systems share the same fundamental routing problem as both optical packets and aircraft must continuously move within the network, while avoiding conflicts. In this paper, we explore the use of hot potato and deflection routing algorithms, which are established routing methods in optical communication networks, in the conflict-free routi...
متن کاملFlying-Hot-Wire Study of Flow Past an NACA 4412 Airfoil at Maximum Lift
Hot-wire measurements have been made in the boundary layer, the separated region, and the near wake for flow past an NACA 4412 airfoil at mad mum lift. The Reynolds number based on chord was about 1,500,000. Special care was taken to achieve a two-dimensional mean flow. The main instrumentation was a flying hot wire; that is, a hot-wire probe mounted on the end of a rotating arm. The probe velo...
متن کاملA Hierarchical SLAM/GPS/INS Sensor Fusion with WLFP for Flying Robo-SAR's Navigation
In this paper, we present the results of a hierarchical SLAM/GPS/INS/WLFP sensor fusion to be used in navigation system devices. Due to low quality of the inertial sensors, even a short-term GPS failure can lower the integrated navigation performance significantly. In addition, in GPS denied environments, most navigation systems need a separate assisting resource, in order to increase the avail...
متن کاملModeling and Characterization of the Sensitivity of a Hot-wire Particle Velocity Sensor
The sensitivity of an innovative micromachined acoustic sensor consisting of four hot-wires is analyzed theoretically and experimentally. An analytical model is presented that describes both the air flow and the temperature profile in and around the probe. The presence of the chip surface in the vicinity of the wires influences the acoustic flow, while also affecting the temperature distributi...
متن کاملOptimization of Single-Sensor Two-State Hot-Wire Anemometer Transmission Bandwidth
Hot-wire anemometric measurements of non-isothermal flows require the use of thermal compensation or correction circuitry. One possible solution is a two-state hot-wire anemometer that uses the cyclically changing heating level of a single sensor. The area in which flow velocity and fluid temperature can be measured is limited by the dimensions of the sensor's active element. The system is desi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 1990
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.56.475