Flywheel proof mass actuator for active vibration control
نویسندگان
چکیده
منابع مشابه
Microgravity test of a proof-mass actuator for active vibration control
The paper presents the results of an active structural control experiment performed under microgravity conditions. The test has been conducted during an ESA parabolic flight campaign, aboard a Caravelle aeroplane. The structure is a simple cantilevered steel beam with a proof-mass actuator located at the free end. The actuator is a voice-coil linear dc motor built in house with simple and readi...
متن کاملFeedback control unit with an inerter proof-mass electrodynamic actuator
In this study the use of an inerter is considered for active vibration control of a structure excited by white noise. The structure is modelled as a single degree of freedom system and the control system consists of a vibration absorber with a mass suspended on a spring, a damper and an inerter. The absorber is equipped with a reactive force transducer velocity of the structure under control me...
متن کاملRotor Position and Vibration Control for Aerospace Flywheel Energy Storage Devices and Other Vibration Based Devices
Flywheel energy storage has distinct advantages over conventional energy storage methods such as electrochemical batteries. Because the energy density of a flywheel rotor increases quadratically with its speed, the foremost goal in flywheel design is to achieve sustainable high speeds of the rotor. Many issues exist with the flywheel rotor operation at high and varying speeds. A prominent probl...
متن کاملFuzzy Control Of A Vibration Actuator
A fuzzy logic based digital sinusoidal acceleration waveform amplitude controller for a PC based electrodynamic vibration actuator is presented. The fuzzy logic control (FLC) purpose is to reproduce pre-defined sinusoidal acceleration amplitude at the vibration table of a vibration actuator system. Sinusoid vibration profiles (sine and linear sine sweep) are considered for a closed-loop control...
متن کاملDynamics Characterizations of Dielectric Electro-Active Polymer Pull Actuator for Vibration Control
Elastomeric dielectric material has recently become a new alternative for actuator technology. The characteristics of dielectric elastomers placed between two electrodes to withstand large strain when electrodes are charged has attracted the attention of many researcher to study this material for actuator technology. Thus, in the past few years Danfoss Ventures A/S has established their own die...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of The Polish Academy of Sciences-technical Sciences
سال: 2023
ISSN: ['2300-1917', '0239-7528']
DOI: https://doi.org/10.24425/bpasts.2023.144605