Force transmissibility and vibration power flow behaviour of inerter-based vibration isolators
نویسندگان
چکیده
منابع مشابه
An electromagnetic inerter-based vibration suppression device
This paper describes how an inerter-based device for structural vibration suppression can be realized using an electromagnetic transducer such as a linear motor. When the motor shaft moves, a difference of voltage is generated across the transducer coil. The voltage difference is proportional to the relative velocity between its two terminals. The electromagnetic transducer will exert a force p...
متن کاملVibration isolators for portable vibrating tools. Part 6. Problems concerning vibration force measurement.
Multi-point independent simultaneous force measurements were made to investigate the vibration force distribution on the palm and to determine one representative point on it for the purpose of field survey. The phase relationships between the force and the acceleration were also pursued. In connection with vibration force transmission, important effects such as vector, bypassing and mechanical ...
متن کاملNumerical Modelling of Rubber Vibration Isolators
An important cause for interior noise in vehicles is structure-borne sound from the engine. The vibrations of the source (engine) are transmitted to the receiver structure (the vehicle) causing interior noise in the vehicle. For this reason the engine is supported by rubber isolators for passive isolation in especially the high-frequency region. To make a good judgment of the characteristics of...
متن کاملVibration Power Flow: A Critical Review
Prediction and measurement of vibration power flow in structures are both important for locating vibration sources and sinks and for confirming vibration propagating paths. From the point of view of noise and vibration control in industries, the method is very important for practical reasons. Consequently, it is essential to address the state of the art of the method, its effectiveness and limi...
متن کاملVibration suppression of cables using tuned inerter dampers
This paper considers the use of a tuned inerter damper (TID) system for suppressing unwanted cable vibrations. The TID consists of an inerter, a device that exerts a force proportional to relative acceleration, coupled with a parallel spring and damper. It may be thought of as similar to a tuned-mass-damper, but requiring two terminals. As a two terminal device, the performance of the TID is co...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2016
ISSN: 1742-6588,1742-6596
DOI: 10.1088/1742-6596/744/1/012234