Formation of Transformation Textures and Plastic Anisotropy in Hot-rolled Steel Sheets
نویسندگان
چکیده
منابع مشابه
Stabilisation of ferrite in hot rolled d-TRIP steel
A steel has recently been designed to benefit from the deformation induced transformation of retained austenite present in association with bainitic ferrite. It has as its major microstructural component, dendrites of d-ferrite introduced during solidification. The d-ferrite replaces the allotriomorphic ferrite present in conventional alloys of this kind. The authors examine here the stability ...
متن کاملMechanical Property Determination of Heavy Steel Plates and Cold Rolled Steel Sheets by Micro-magnetic Ndt
The presentation is to results recently obtained in collaborative research in the European steel programme performed by Fraunhofer-IZFP and co-operative steel industry producing rolling products. The objective was and is to characterize i.e. to predict mechanical properties like hardness, yield strength, tensile strength, deep drawing parameters rm and ∆r, etc., mainly online by use of contact-...
متن کاملStatistical discriminator of surface defects on hot rolled steel
A statistical approach to defect detection and discrimination has been applied to the case of hot rolled steel. The probability distribution of pixel intensities has been estimated from a small set of images without defects, and this distribution is used to select pixels with unlikely values as candidates for defects. Discrimination of true defects from random noise pixels is achieved by a dyna...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
The Influence of Sheet Metal Anisotropy on Laser Forming Process
Cold-rolled sheet metal that is often used in laser forming exhibits anisotropic properties, which are mostly caused by preferred orientations of grains developed during the severe plastic deformation such as cold rolling. In the present study, the textures of cold-rolled mild steel sheets are characterized and the influence of the plastic anisotropy on laser forming process is investigated. De...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1989
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.75.6_941