Forming Pressure Control in First Stage Drawing and Re-drawing of Cylindrical Shells with Rubber Die
نویسندگان
چکیده
منابع مشابه
Forming Behaviour in Laser Shock Drawing
Through the continuing trend of miniaturization new cost efficient and fast methods for processing small parts are required. In this paper a new non-mechanical process for the forming process of micro deep drawing is presented. This new deep drawing process utilizes a laser initiated plasma shock wave at the target, which forms the sheet. Several pulses can be applied at one point and therefore...
متن کاملEvaluation of Forming Severity and Thickness Variation in Deep Drawing Process
This paper presents a new methodology for complete solution of general shape deep drawn parts. Evaluation of forming severity, estimation of the punch load and prediction of the thickness variation are the major results obtained in this work. The punch work is the summation of the homogenous work of flange deformation and bending and frictional works. To evaluate the strain energy of the flange...
متن کاملextra high limiting drawing ratio (ldr=9) cylindrical deep drawing based on finite element and experiment
deep drawing of cylindrical shapes with high limiting drawing ratio (ldr) values is relatively difficult. annealing is a further operation, which in turn adds costs and consumes significantly time to the forming process. in the present work, cylindrical cups from brass sheet were made with only limited anneal during few steps, but having ldr of 9 that is about 2 times higher than previous works...
متن کاملOn the Optimum Die Shape in Rod Drawing Process Considering Work-Hardening Effect of Material
The assessment of the influence of the work-hardening of material on the optimum die profile and drawing force in rod drawing process is the main objective of the present paper. The upper bound solution, based on the assumption of perfect plasticity, has been extended to consider the work-hardening of the material during the rod drawing process through curved dies. Analytical results of drawin...
متن کاملOn the optimum die angle in rod drawing process considering strain-hardening effect of material
In this paper, rod drawing process of strain-hardening materials is investigated by analytical, numerical and experimental methods. The classic upper bound solution, based on the assumption of perfect plasticity, has been extended to consider the work-hardening of the material during the drawing process. For a given process conditions and mechanical properties of the rod material, the power ter...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of JSME
سال: 1974
ISSN: 0021-3764,1881-1426
DOI: 10.1299/jsme1958.17.409