Four-elements model representation of rubber vibration isolator.
نویسندگان
چکیده
منابع مشابه
The Development of an Intelligent Hybrid Active-passive Vibration Isolator
A hybrid active-passive vibration isolator made up of electromagnetic actuator and air spring in parallel can be used to effectively isolate the broadband and line spectrum vibration of mechanical equipment simultaneously. However, due to its reliability and safety problems caused by the impact, its application in ships is limited. In this paper, an impactresistant structure and an air gap self...
متن کاملNumerical Modelling of Rubber Vibration Isolators
An important cause for interior noise in vehicles is structure-borne sound from the engine. The vibrations of the source (engine) are transmitted to the receiver structure (the vehicle) causing interior noise in the vehicle. For this reason the engine is supported by rubber isolators for passive isolation in especially the high-frequency region. To make a good judgment of the characteristics of...
متن کاملOn Parameter Study of Cubic Nonlinear Vibration Isolator
The purpose of optimizing isolator parameters is to have a system that is stiff at low frequency but soft in high frequency. However, in this case a small amount of transmitted force will cause a large displacement in isolator. Exceeding the allowable relative displacement may cause serious damage to the system. Therefore a trade off between the transmitted force, which is indicated by absolute...
متن کاملMechatronic Vibration Isolator for the Microtechnics with Real-time Interaction
A mechatronic vibration isolation system has been developed on the basis of system theory. This equipment integrates mechanics, pneumatics and electronics in synergistic co-operation. The electronic control is responsible for the dynamic behaviour and the special computing transfer block for the real time interaction and compensation of floor vibration disturbances. INTRODUCTION The method for ...
متن کاملTaber vibration isolator for vacuum and cryogenic applications
We present a procedure for the design and construction of a passive, multipole, mechanical high-stop vibration isolator. The isolator, consisting of a stack of metal disks connected by thin wires, attenuates frequencies in the kilohertz range, and is suited to both vacuum and cryogenic environments. We derive an approximate analytical model and compare its predictions for the frequencies of the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1988
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.54.531