Fractional-Order Surge Control of Active Magnetic Bearings Suspended Compressor
نویسندگان
چکیده
منابع مشابه
A Compressor Surge Control System: Combination Active Surge Control System and Surge Avoidance System
A novel method for combining active surge control system (ASCS) and surge avoidance system (SAS) for a centrifugal compressor is presented. ASCS is a promising method to improve compressor operating area by stabilizing surge. However, this method is not applied yet in industrial compressors. Safety issue is considered in implementing the ASCS. A failure in ASCS may endanger the compressor by en...
متن کاملCompressor Surge Suppression by Second-Order Sliding Mode Control Technique
Surge is one of the two main dynamic instabilities that can occur in compressor systems (the other is the rotating stall) preventing their satisfactory operation and being potential cause of serious damages. In this paper we consider a Close Coupled Valve (CCV) as actuator, and we suggest the use of a second-order sliding-mode (2-SM) technique for the active control of the surge phenomenon. We ...
متن کاملIntroducing Back-up to Active Compressor Surge Control System
A novel method for introducing a back-up system to an active compressor surge control system is presented in this paper. Active surge control is a promising method for extending the compressor map towards and into the unstable area at low mass flow by stabilizing the surge phenomenon. The method also has potential for allowing operation at higher efficiencies. However, a failure in the active s...
متن کاملActive Magnetic Bearings (amb)
A magnetic bearing is a bearing which supports a load using magnetic levitation. Magnetic bearings support moving machinery without physical contact, for example, they can levitate a rotating shaft and permit relative motion without friction or wear. In active magnetic bearings (AMB) a stable equilibrium is achieved by means of one or more control loops. The use of control loop for maintaining ...
متن کاملCentrifugal compressor surge and speed control
Previous work on stabilization of compressor surge is extended to include control of the angular velocity of the compressor. First a low-order centrifugal compressor model is presented where the states are mass flow, pressure rise, and rotational speed of the spool. Energy transfer considerations are used to develop a compressor characteristic. In order to stabilize equilibria to the left of th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Actuators
سال: 2020
ISSN: 2076-0825
DOI: 10.3390/act9030075