Fracture Criteria for Unidirectional Discontinuous Fiber Reinforced Plastics with Side Notches
نویسندگان
چکیده
منابع مشابه
Some observations in grinding unidirectional carbon fibre-reinforced plastics
This paper investigates the grinding performance of epoxy matrix composites reinforced by unidirectional carbon fibres, using an alumina grinding wheel. Emphasis was placed on understanding the effect of fibre orientations and grinding depths on the grinding force and surface integrity, and on understanding the grinding mechanisms, with a comparison to orthogonal cutting. It was found that grea...
متن کاملBlast resistance of unidirectional fiber reinforced composites
Three-dimensional transient deformations of a laminate comprised of several unidirectional fiber reinforced layers perfectly bonded to each other and subjected to a blast load are analyzed by the finite element method with an in-house developed, verified and fully validated code with rate-dependent damage evolution equations for anisotropic bodies. The continuum damage mechanics approach employ...
متن کاملDiscontinuous fiber-reinforced composites above critical length.
Micromechanical physics of critical fiber length, describing a minimum filament distance for resin impregnation and stress transfer, has not yet been applied in dental science. As a test of the hypothesis that 9-micron-diameter, 3-mm-long quartz fibers would increase mechanical strength over particulate-filled composites, photocure-resin-pre-impregnated discontinuous reinforcement was incorpora...
متن کاملMode I Interlaminar Fracture Toughness of Unidirectional Fiber-Reinforced Polymer Matrix Composites
1.1 This test method describes the determination of the opening Mode I interlaminar fracture toughness, GIc, of continuous fiber-reinforced composite materials using the double cantilever beam (DCB) specimen (Fig. 1). 1.2 This test method is limited to use with composites consisting of unidirectional carbon fiber and glass fiber tape laminates with brittle and tough single-phase polymer matrice...
متن کاملUltrasonic Examination of Fiber Reinforced Plastics Using Phased Array Transducers
This paper presents a data fusion method between the results of ultrasound using phased array at 5MHz frequency and those obtained through eddy current examination at 1-10MH frequency. The obtained results are compared with destructive tests, a very good correlation being obtained. The effects of delamination over the properties of CFRP are studied using dynamic mechanical analyzer, emphasizing...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 2008
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.57.725