Fretting Wear and Recent Studies
نویسندگان
چکیده
منابع مشابه
Numerical Modeling of Fretting Wear
In this paper, a review of some techniques proposed in the literature for modelling fretting wear is presented. Fretting wear occurs when surfaces are degraded and materials are removed due to a small relative oscillatory motion between two contact surfaces. Due to the continuous change in the shape of a structure during its lifetime, the design of engineering components subjected to fretting w...
متن کاملInterference Assembly and Fretting Wear Analysis of Hollow Shaft
Fretting damage phenomenon often appears in the interference fit assembly. The finite element model of hollow shaft and shaft sleeve was established, and the equivalent stress and contact stress were computed after interference assembly. The assembly body of hollow shaft and shaft sleeve was in whirling bending load, and the contact status (sticking, sliding, and opening) and the distribution o...
متن کاملFretting Wear between a Hollow Sphere and Flat Surface
Wear particles in a hard disk drive may cause the head/disk interface to fail. We have experimentally investigated wear particle generation resulting from fretting wear between the dimple on the suspension and the gimbal spring. We have found that increasing the normal load as well as using a low friction coating reduces the formation of wear particles. INTRODUCTION Examination of failed hard d...
متن کاملEvaluation of fretting wear on the femoral stem surface
Fretting wear on polished femoral stems has been well documented in clinical reports, but in vitro simulation to replicate this wear has seldom been attempted and only limited success has been achieved. In the present study, fretting wear was successfully reproduced on the stem surface by incorporating initial stem implantation in a sawbone through bone cement and utilisation of saline solution...
متن کاملFretting wear in self-piercing riveted aluminium alloy sheet
Fretting wear in aluminium alloy AA5754 joined by self-pierce riveting (SPR), a relatively new fastening technique increasingly used in vehicle structures, has been investigated in this paper. Surface damages have been induced when a joint experienced a sinusoidal cyclic tension-tension load. Various degradation zones have been characterised in the contact surfaces between the aluminium sheets,...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: CORROSION ENGINEERING
سال: 1988
ISSN: 0010-9355,1884-1155
DOI: 10.3323/jcorr1974.37.1_34