Fundamental Study of Plunge Grinding Process (5th Report)
نویسندگان
چکیده
منابع مشابه
Fundamental Study on Cross Axis Grinding Method
In this study, it is experimentally investigated that the surface generation process in the cross axis grinding method with small diameter grinding wheel. In this grinding method, workpiece surface speed and sum of both wheel working surface speed and wheel feed rate crossed each other. Therefore, it is the largest characteristic that the cross angle, which is defined as the angle between the w...
متن کاملStudy of Traverse Grinding Process (1st Report) Accumulation Phenomenon and Size Generation Mechanism in Traverse Grinding
plicated processes on the wheel surf ace along the wheel width. In order to make these processes clear, the experimental analysis of traverse grinding was conducted by widely changing the speed ratio, Kv, the setting depth of wheel, ‡TMT, and the number of total steps, m, (the ratio of the wheel width over the traverse feed per one revolution of the workpiece). The following results were obtain...
متن کاملRealisation of grinding-hardening in workpieces of curved surfaces—Part 1 Plunge cylindrical grinding
This paper investigates the feasibility to achieve grinding-hardening in a plunge cylindrical grinding process. To understand the mechanisms, a temperature-dependent finite element heat transfer model incorporating a triangular moving heat source was developed to describe the temperature field, thus to predict the thickness of the grinding-hardened layer. The analysis carried out included the v...
متن کاملStudy of Thresholds to Burning in Surface Grinding Process
150 / Vol. XXVII, No. 2, April-June 2005 ABCM P. R. de Aguiar F. R. L. Dotto and E. C. Bianchi Lab. of Data Acquisition and Signal Processing Department of Electrical Engineering, Department of Mechanical Engineering São Paulo State University – Unesp Av. Luiz Edmundo C. Coube S/N, Vargem Limpa 17033-360 Bauru, SP. Brazil [email protected] [email protected] [email protected] Study of Th...
متن کاملStudy on the Virtual Wheel and Grinding Process
In this paper the modeling method of object entity in the environment of virtual is introduced and the three-dimensional simulation model of grinding wheel is established in Visual C++ programming language and OpenGL tool. The simulated experiment is made, which can indicate the effect of different parameters to grinding process. It proved the reliability and practicability of virtual wheel thr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Precision Engineering
سال: 1977
ISSN: 0374-3543
DOI: 10.2493/jjspe1933.43.1087