Fuzzy Robust Design of Dynamic Vibration Absorbers
نویسندگان
چکیده
منابع مشابه
Concurrent Design of Input Shaping and Vibration Absorbers
Systems that exhibit flexible dynamics are susceptible to vibration caused by changes in the reference command, as well as, from external disturbances. Feedback control is an obvious choice to deal with these vibrations, but in many cases, it is insufficient or difficult to implement. Input shaping has proven beneficial for reducing vibration that is caused by changes in the reference command. ...
متن کاملdesign of an analog fuzzy logic controller chip
fuzzy logic has been developed over the past three decades into a widely applied techinque in classification and control engineering. today fuzzy logic control is one of the most important applications of fuzzy set theory and specially fuzzy logic. there are two general approachs for using of fuzzy control, software and hardware. integrated circuits as a solution for hardware realization are us...
15 صفحه اولSweeping piezoelectric patch vibration absorbers
This paper presents a simulation study concerning the low-mid frequencies control of flexural vibration in a lightly damped thin plate, equipped with five time-varying shunted vibration absorbers. The panel is excited by a rain-on-the-roof broad frequency band stationary disturbance. The absorbers are composed of piezoelectric patches connected to time-varying RL shunt circuits. Continuous, swe...
متن کاملDesign of robust carrier tracking systems in high dynamic and high noise conditions, with emphasis on neuro-fuzzy controller
The robust carrier tracking is defined as the ability of a receiver to determine the phase and frequency of the input carrier signal in unusual conditions such as signal loss, input signal fading, high receiver dynamic, or other destructive effects of propagation. An implementation of tight tracking can be understood in terms of adopting a very narrow loop bandwidth that contradict with the req...
متن کاملinvestigation into the importance of pre-design procedure in vibration absorbers installations
in this work an improved method for designing a linear vibrational absorber, excited by random vibrations is presented and analyzed. first, analytical expressions, for non-stationary white noise accelerations, are derived. the criterion is different from the conventional criteria, used for structural design under random vibration, and it is based on minimum displacement or acceleration response...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Shock and Vibration
سال: 2016
ISSN: 1070-9622,1875-9203
DOI: 10.1155/2016/2081518